Bodet HMT Installation Instructions Manual page 23

(entering 00:00 will stop the countdown at midnight on the last
day).
The hours blink (0 to 23). Select with the [R] key.
Press [S] to validate the hour and move on to select the
minutes.
The minutes blink (0 to 59). Select with the [R] key.
Press [S] to validate.
Note : During the last day the countdown changes to Hour/Min
countdown. During the last hour, the countdown changes to
Min/Sec countdown.
. The readout returns to normal mode with the chronometer
7
taken into account (*) (see "[Sel] push button (inside
clock only)" on page 16 for the functioning of the
chronometer).
(*) You must not forget to program the alternation of the timing using the PROG menu (see
page 20).
By selecting the " Chro " menu and validating the "Up" or "Down" selection all the possible
programmed alternating displays will be blocked. Only the timer is active. By selecting
"dAy", the alternating displays operate normally except in the case of "DAYd" when the
Day countdown becomes "HMS" countdown then only the countdown is displayed.
In order to exit from the display of the countdown or up, just enter the "TIME" menu.
23