A local telephone company may make changes in its communications facilities or procedure. If these changes could reasonably be expected to affect the use of the KF350 or compatibility with the network, the telephone company is required to give advanced written notice to the user, allowing the user to take appropriate steps to maintain telephone service.
1. INTRODUCTION E. Notice of Radiated Emissions The KF350 complies with rules regarding radiation and radio frequency emission as defined by local regulatory agencies. In accordance with these agencies, you may be required to provide information such as the following to the end user.
3. TECHNICAL BRIEF 3.1.7 GPIO map Over a hundred allowable resources, KF350 is using as follows except dedicated to SIM and Memory. KF350 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table Table 5 S-Gold3 GPIO pin Map...
ON does not reach VIHdet (Vbat-0.8 ~ Vbat-0.3) the above-mentioned bit won’t be set. To support Remote power on function for factory mass production, applied an analog switch as following figure. As monitoring the RPWRON and Key matrix KP_OUT(2) & KP_IN (0), KF350 system recognize whether remote power on or End-key pushed...
3. TECHNICAL BRIEF 3.4 SIM & uSD interface KF350 supports 1.8V & 2.9V plug in SIM, SIM interface scheme is shown in (Figure 8). SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with BBP(S-Gold3) and the SIM power supply enabled by PMIC.
3. TECHNICAL BRIEF 3.5 Memory 1Gbit Flash & 512Mbit DDRAM employed on KF350 with 8 & 16 bit parallel data bus thru ADD(0) ~ ADD(24). The 1Gbit Nand Flash memory with DDRAM stacked device family offers multiple high- performance solutions.
Figure 15 JTAG & ETM(Embedded Trace Module) interface connector In case of KF350 mass production, the JTAG & ETM interface connector will not be mount on board. That is only for developing and software debugging purpose.( It will not be mounted on mass...
3. TECHNICAL BRIEF 3.12 Audio KF350 Audio signal flow diagram as following diagram. PMB8877 9877 BT+ FM Ear M I C Figure 16 Audio signal flow diagram 3.12.1 Audio amplifier Audio amplifier sub system IC is an audio power amplifier capable of delivering 1.2 W of continuous average power into a mono 8ߟ...
Need help?
Do you have a question about the KF350 and is the answer not in the manual?
Questions and answers