Hydraulic & Transmission Suction Oil Filter; Hydraulic & Transmission Strainer; Transmission Oil Drain - Mahindra 3535 Operator's Manual

Hydraulic and Transmission Suction Oil Filter
Change Hydraulics and Transmission oil filter (A) initially at
50 hrs. and subsequently at every 350 hrs. of operation.
These Spin-on type filters are located behind on RH side of
the tractor. Remove old spin-on filters.
Prime the new spin-on filter with clean oil, and fit them.
Hydraulic and Transmission Strainer
Clean suction strainer during every oil change. The suction
strainer (B) is located on RH side of rear housing and can
be removed as follows:
1) Remove suction filter of Hydraulic & Transmission.
2) Remove the Cover Plate (B) by unscrewing four bolts.
3) Pull the suction strainer out from housing.
4) Clean the strainer in clean diesel fuel, using a soft
brush, then blow dry with compressed air.
5) Refit the strainer.
6) Refit the cover plate and suction filter.
For Service / Replacement of strainer contact your
Mahindra Dealer.

Transmission Oil Drain

Drain plug (C) is provided on the transmission for draining
transmission oil. The drain plug located at the bottom of
the transmission case.
35 Series-HST, Model - 3535, 4035, 4535 & 5035
Hydraulics & Transmission
Note : The Hydraulic and Transmission filter
though resembles with engine oil filter, it differs
in construction and usage. Hence these are not
interchangeable.
A
B
C
75