Table of Contents
Advertisement
1. INSTALLATION
(1) Unpacking
-
To unpack the SFX-30:
1. Open the carton.
2. Remove the accessories (handset, recording paper roll, etc.) from the carton.
3. Remove the fax machine along with the foam braces on both sides.
4. Remove the polyethylene wrapping around the fax machine.
5. Remove the transportation tapes.
6. Save the carton and the foam braces for later storage and/or shipping.
7. Place the machine where there is access to an AC outlet and a modular phone jack. (Be sure to observe the
precautions below.)
Placement precaution
Avoid placing the SFX-30
in
humid or
dusty
places,
or
in
places
where it will be exposed to excessive heat
(direct sunlight, heaters, etc.).
Do not step on or set anything on the AC cord. DAMAGE TO THE AC CORD IS A SAFETY RISK AND CAN
cAusE A FIRE.
-
. Install the
unit only on a stable surface.
.
Do not connect
the
SFX-30 to the same AC outlet as appliances that generate large amounts of interference
(heaters with thermostats, appliances with motors, etc.). It is best to use a completely separate electrical outlet.
Keep the SFX-3Oaway from water. If water accidentally enters the unit, unplug the AC power cord 'immediately.
DO NOT SWITCH THE UNIT ON AGAIN. Contact an authorized Sanyo service center or dealer.
Handling precaution
b
. Do not remove any parts that are held in place with screws. (The SFX-30 does not contain any user-serviceable
items).
. Maintain standard room temperature 5°C – 35°C (41°F – 95"F) during use. Do not subject the unit to shock or
vibration. Do not move the unit while it is in use.
A rapid increase in room temperature in cool weather can cause condensation to form inside the unit. If this
happens, wait at least 15 minutes after turning the unit on before attempting to operate it.
Failure to do so may result in paper jams and/or poor print quality.
When cleaning the cover or operation panel of the unit, wipe gently using a damp cloth to which a small amount
of a neutral detergent has been added. NEVER USE SOLVENTS OR CHEMICALLY TREATED CLOTHS.
(2) Telephone line and AC connections
~Connecting to AC
I Connecting to telephone line
The SFX-30 should not share a modular jack with other communication
equ!pment, as this may obstruct the proper tunctloningof the umt.
L
—1 —
Advertisement
Table of Contents
