Gloss Mode - Kyocera Mita WP31C Operation Manual

3.8.2

Gloss Mode

Note
The gloss mode, when set to High, increases the effect of glossiness in printing by reducing
the printing speed by half. The gloss mode is not available when Transparency is
selected as the paper type setting.
Depending on the paper used, printing in gloss mode may cause wrinkle in paper. To
reduce wrinkle, try using thicker paper.
The default gloss mode is Low. To confirm or change the gloss mode, proceed as follows:
1 1 1 1
Press the MENU key.
2 2 2 2
Press the or
Print Quality
3 3 3 3
Press the key.
4 4 4 4
Press the or
>Gloss Mode
Low
5 5 5 5
To change the gloss mode, press the ENTER key. A blinking question mark (?)
appears.
>Gloss Mode
? Low
6 6 6 6
Press the or
7 7 7 7
Press the ENTER key to finalize the selection.
8 8 8 8
Press the MENU key. The display returns to Ready.
key repeatedly until Print Quality > appears.
>
key repeatedly until >Gloss Mode appears.
key to change from Low to High.
3-59
3.8 Setting Print Quality