Replacing the Heat Sink
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your
computer, follow the instructions in
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
CAUTION: Incorrect alignment of the heat sink can cause damage to
the system board and processor.
NOTE: The original thermal grease can be reused if the original system
board and fan are reinstalled together. If either the system board or the
fan is replaced, use the thermal pad provided in the kit to make sure that
thermal conductivity is achieved.
Procedure
1
Align the screw holes on the heat sink with the screw holes on the
system board.
2
Tighten the captive screws that secure the heat sink to the system board.
Post-requisites
1
Follow the instructions from step 4 to step 13 in "Replacing the
Board".
2
Replace the
wireless
3
Follow the instructions from step 3 to step 5 in "Replacing the
Cover".
Computer. After working inside your
card.
After Working Inside Your
System
Back
53