Network Setup - Extron electronics ShareLink 200 User Manual

Network Setup

Figure 34.
1
Host Name and Domain Name Panel
Host Name: Enter a host name for the ShareLink 200 device or check Same as
•
WiFi Network name to use the default SSID name.
Domain Name: Enter the domain name for the DNS server.
•
2
IP Setup Panel
Obtain an IP address automatically (default setting): select this option
•
to obtain an IP address automatically from a DHCP server. The default settings are
as follows: IP Address: 192.168.254.254, Subnet Mask: 255.255.255.0,
Default Gateway: 192.168.254.254, DNS Server: 0.0.0.0
Use the following IP address: Select this option to enter a static IP
•
address.
IP Address: Enter an IP address.
Subnet Mask: Enter the corresponding subnet mask.
Default Gateway: Enter the corresponding gateway address.
DNS Server: Enter the corresponding DNS server address.
3
DHCP Server Setup Panel
Auto (default setting): If a DHCP server is available on the network, the
•
ShareLink 200 uses an IP address assigned by the server. If a DHCP server is not
available on the network, the ShareLink 200 uses its internal DHCP server to assign
IP addresses to network devices. The default settings are as follows: Start IP:
192.168.254.11, End IP: 192.168.254.100, Subnet Mask: 255.255.255.0,
Default Gateway: 192.168.254.254, DNS Server: 0.0.0.0
NOTE: In Auto mode, you may use the default settings above or customize the
Disable: Disables the internal DHCP server.
•
1 1
2 2
3 3
4 4
Network Setup
settings, if needed.
ShareLink 200 • Using the Embedded Web Pages 33