Adjusting Incline Wheels; Belt Adjustment; Cleaning; Deck Lubrication - Reebok I-Run RE-14301 User Manual

MAINTENANCE
Proper maintenance is very important to ensure your treadmill is always in top working condition. Improper maintenance
could cause damage or shorten the life of your treadmill and exceed the LIMITED WARRANTY coverage. Inspect and
tighten all parts of the treadmill regularly. Replace any worn parts immediately.

BELT ADJUSTMENT

Belt adjustment and tension performs two functions: adjustment for tension and centering. The running belt has been
adjusted properly at the factory. However transportation, uneven flooring or other predictable reasons could cause the
belt to shift off centre resulting in the belt rubbing with the plastic side rail or end caps and possibly causing damage. To
adjust the belt back to its proper position please follow the directions below. When the running belt is not centred and is
shifted to the right or to the left, it is possible to adjust its position. Remove the Safety Key and unplug the power cord.
Use the Allen wrench and turn both rear roller adjustment bolts clockwise, not more then 90 degrees. Remove the Allen
wrench, insert the Safety Key and plug in the power cord. Run the treadmill a few minutes and observe if WARNING: Do
not over tighten rollers! This will cause premature roller bearing failure!

CLEANING

Routine cleaning of your treadmill will extend the product's life. WARNING: To prevent electrical shock, be sure the
power to the treadmill is OFF and the power cord is unplugged from the wall electrical outlet before attempting any
cleaning or maintenance.
• Never use abrasive or solvents to clean the treadmill. To prevent damage to the computer, keep liquids away and
keep it out of direct sunlight.
• After each workout: Wipe off the console and other treadmill surfaces with a clean, water dampened soft cloth to
remove excess perspiration.
• Weekly: Use of a treadmill mat is recommended for ease of cleaning. Dirt from your shoes contacts the belt and
eventually makes it to underneath the treadmill. Vacuum underneath treadmill once a week.

DECK LUBRICATION

The walking belt has been pre-lubricated at the factory. However, it is recommended that the walking board be checked
periodically for lubrication to ensure optimal treadmill performance. Your treadmill should not have to be lubricated
usually within the first year or 500 hours of use. Every 30 days or 30 hours of operation lift the sides of the walking belt
and feel the top surface of the walking board as far as you can reach. If you feel signs of silicone, no further lubrication is
required. If it feels dry to the touch, follow the instructions below. Please use a non-petroleum based silicone.
24

ADJUSTING INCLINE WHEELS

Your machine has 2 levels of incline – 1% or 4%
To adjust the incline on your I-run simply move the bar that attaches the 2 rear wheels backwards of forwards. When the
wheels are pushed inwards towards the machine the running surface will be at a 4% incline. When the wheels are fully
extended the incline level will be 1 %.
*please note 1% incline level is the lowest point available for the I-run Machine.
25