Toyota GT86 Owner's Manual page 419

Right-hand drive vehicles
Positive (+) battery terminal on your vehicle
Positive (+) battery terminal on the second vehicle
Negative (-) battery terminal on the second vehicle
Connect the jumper cable to ground on your vehicle as shown in
the illustration.
STEP 2
Start the engine of the second vehicle. Increase the engine
speed slightly and maintain at that level for approximately 5
minutes to recharge the battery of your vehicle.
STEP 3
Vehicles with a smart entry & start system only: Open and
close any of the doors of your vehicle with the "ENGINE
START STOP" switch off.
STEP 4
Vehicles without a smart entry & start system: Maintain the
engine speed of the second vehicle and turn the engine
switch to the "ON" position, then start the vehicle's engine.
Vehicles with a smart entry & start system: Maintain the
engine speed of the second vehicle and turn the "ENGINE
START STOP" switch to IGNITION ON mode, then start the
vehicle's engine.
5-2. Steps to take in an emergency
5
419