Control Panel Ne183 - Fiat X2-50 Ducato Cab Owner's Manual

Once connected to a 230V mains supply and
switched on, its operation is fully automatic.
When used as an alternative DC power
supply, with no battery in circuit, the unit will
supply a suitable output for use with pump,
lighting, TV, radio etc.
The facility for drawing 12V supply from the
cab battery is intended for standby situations
only, and care should be taken not to run the
cab battery too low, some models feature
cab battery protection circuitry.
If the cab battery has been used on site, then
the engine driven alternator will recharge
both it and the leisure battery whilst
travelling.
However, once the cab battery is fully
charged, the alternator will supply a trickle
charge only to the leisure battery.

CONTROL PANEL NE183

CONTROLS (MODEL/RANGE SPECIFIC):
ON / OFF:
Press this key to turn on the control panel.
In stand-by mode (without active controls)
the NE183 control panel with the NE184
control unit consumes a total of approx.
39mA. Hold this key down for over
3 seconds to turn off the control panel,
reducing total consumption to just 13.5mA.
If the leisure battery voltage drops below 10V
for over 2 minutes the control panel turns
itself off.
Electrical Systems
PUMP:
Key with warning light to turn the PUMP on
and off. The pump does not work when the
control panel is off or if the engine is running.
49