Hardware Installation
CHAPTER
4
OVERVIEW
Audio connections. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
A typical 8M setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
Synchronization . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
RACK INSTALLATION AND HEAT
When installing your MOTU audio interface in a
19-inch rack, leave extra space above, below,
behind and on either side of the unit to provide
adequate ventilation and heat dispersion. Do not
install it near other gear that generates excessive
heat.
THUNDERBOLT AUDIO INTERFACE SETUP
Use this setup if you want to use your MOTU
device as an audio interface, and your computer
has Thunderbolt™.
Use a standard Thunderbolt cable.
■
Place it at the end of the Thunderbolt chain (up
■
to six devices in the chain, not including the
computer).
See "Software installation" on page 33.
■
35
Need help?
Do you have a question about the 8M and is the answer not in the manual?
Questions and answers