Additional functions
Programming
Calling up programming
Set a programme, set a status
How to save the settings
How to avoid saving the settings
46
You can change the default settings of the programme
options (see chart). Several settings can be altered in
succession.
After calling up programming, P (programme), S (status) and
numbers appear in the cooking zone display. This shows the
current setting.
After leaving programming, an automatic reset is carried out.
It is finished when the booster indicator lamp lights up.
Do not switch the cooktop on before reset has finished,
otherwise a fault message will appear and the reset will be
carried out again.
^ While the cooktop is switched off, touch the sensor
switches s and B I/II at the same time until the
appropriate control light flashes.
^ Cooktops with four or more cooking zones
Touch the front left sensor of the cooking zone.
^ Cooktops with three cooking zones
Touch the left sensor of the cooking zone.
^ Touch the + or - sensors to set the required programme.
^ Touch the front right cooking zone sensor.
^ Touch the + or - sensors to set the required status (see
chart).
^ Touch the s sensor until the displays go out.
^ Touch the B I/II sensor until the displays go out.