Page 1
PROPANE TANK TOP CONSTRUCTION HEATER USER’S MANUAL AND OPERATING INSTRUCTIONS MODELS: TT-360 ANS Z83.7-2011 CSA 2.14-2011 Adequate ventilation must be provided. GENERAL HAZARD WARNING FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER, CAN RESULT IN DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS, OR DAMAGE FROM THE HAZARDS OF FIRE, EXPLOSION, BURN.
TABLE OF CONTENTS General Safety Information ................3 - 4 Specifications ......................Product Features ..................... Heater Assembly ....................... Wiring Diagram ......................Propane Safety ......................Refilling The Propane Gas Tank ................Connecting Heater to Gas Supply ................8 - 9 Checking For Leaks ....................10 Lighting &...
PROPANE TANK TOP HEATER PROPANE TANK TOP CONSTRUCTION HEATERS The heater is designed and approved for use as a construction heater under ANSI Z83.7, CSA 2.14. CHECK WITH YOUR LOCAL It is hard to anticipate every use which may be made of this heater. FIRE SAFETY AUTHORITY IF YOU HAVE QUESTIONS ABOUT APPLICATIONS.
PROPANE TANK TOP HEATER GENERAL SAFETY INSTRUCTIONS Accidents are always tragic especially because so many of them could have been prevented with a little care and judgment. There are some basic good practices, we hope you will follow for safe use of your heater. IMPORTANT SAFETY INFORMATION •...
PROPANE TANK TOP HEATER TT360 SERIES HEATER ASSEMBLY Tools Required: Estimated Assembly Time: Contents: Phillips head screwdriver 5 minutes Tank Top Heater (1) Tank Collar Bracket (1) M4x8 Machine Screws (2) DUAL BURNER MODEL The tank collar bracket must be assembled before the heaters can be attached to the propane tank. 1.
PROPANE TANK TOP HEATER WIRING DIAGRAM ELECTRODE black earth yellow THERMOCOUPLE yellow M,P,U SAFETY VALVE NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
PROPANE TANK TOP HEATER PROPANE SUPPLY This heater requires a 20 lb propane cylinder for operation. (Not included). The propane (LP) gas tank must also be equipped with the following: • A collar to protect the propane gas valve. • A shutoff valve terminating a Propane gas cylinder valve outlet as specified in the American National Standard for Compressed Gas Cylinder Valve Outlet and Inlet Connections.
PROPANE TANK TOP HEATER CONNECTING HEATER TO PROPANE TANK Read and understand all safety information before connecting heater to propane tank. 1. Place heater onto tank with tank collar bracket over tank collar (Fig. 2). Mounting bolt knob should be positioned to the outside of tank collar and be positioned as closely as possible directly opposite to the cylinder valve outlet.
Page 10
PROPANE TANK TOP HEATER CONNECTING HEATER TO PROPANE TANK FIGURE 2 NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
PROPANE TANK TOP HEATER CHECKING FOR LEAKS Check all gas connections with a 50/50 soap and water solution to be sure they are tight and leak proof. The formation of bubbles indicate a gas leak. Correct all leaks before using the heater. •...
Page 12
PROPANE TANK TOP HEATER LIGHTING INSTRUCTIONS WHEN USING MATCH (CONTINUED) FIGURE 3 1. STOP! Read all safety information first. 2. Turn heater regulator knob counterclockwise to (OFF) [ ] position. 3. Slowly Open Cylinder valve by turning counterclockwise 4. Wait five(5) minutes to clear out any gas. Then smell for gas, including near the floor.
Page 13
PROPANE TANK TOP HEATER TURNING OFF THE HEATER 1. Tightly close propane tank valve by turning fully clockwise 2. Turn the heater regulator knob to the (OFF) [ ] position. Wait at least 30 minutes for the heater to cool before handling heater.
Page 14
PROPANE TANK TOP HEATER LIGHTING INSTRUCTIONS FOR PIEZO IGNITION MODELS (CONTINUED) 1. Stop! Read all safety information first. 2. Turn heater regulator knob counterclockwise to (OFF) [ ] position. WARNING: Stand to the side of unit while lighting. Do not stand or have any part of your body over or near the heater while lighting.
PROPANE TANK TOP HEATER LIGHTING IN WINDY AREAS When using this heater indoors where there is wind, it will be necessary to use a match or long stem butane lighter to ignite the burner. It may be difficult to keep the match lit long enough under windy conditions. Follow the “Lighting instructions when Using a Match”...
PROPANE TANK TOP HEATER TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION 1. Unit will not light. 1. Valve on propane cylinder not open. 1. Open cylinder valve by turning counterclockwise. 2. Propane cylinder empty 2. Have cylinder refilled. 3. Regulator not in "Low" position 3. Turn regulator to "Low" position. 4. Excess flow device triggered. 4. Close cylider valve, wait 5 minutes and reopen slowly. 5. Defective Regulator. 5. Replace Regulator assembly. 2. Burner will not stay lit when 1. Tilt switch open 1. Correct alignment of unit to ensure it is vertical. gas valve plunger released. 2. Wiring of thermocouple 2. Check wiring connections are properly engaged. 3.
WARRANTY LIMITED WARRANTY: This limited warranty is extended to the original retail purchaser of this Duraheat Forced Air/Convection/Radiant Heater and warrants against any defect in materials and workmanship for a period of one (1) year from the date of retail sale. World Marketing of America, Inc., at it’s option, will either provide replacement parts or replace or repair the unit, when properly returned to the retailer where purchased or one of our service centers as directed by World Marketing, within one (1) year of retail purchase.
WARRANTY REGISTRATION IMPORTANT: We urge you to fill out your warranty registration card within fourteen (14) days of date of purchase. You can also register your warranty on the internet at www.worldmkting.com. Complete the entire serial number. Retain this portion of the card for your records.
Need help?
Do you have a question about the TT-360 and is the answer not in the manual?
Questions and answers
where do I order parts for tt360?