6. Capacity table 6.1 MSC-07CRN1 SUMMER OUTDOOR TEMPERATURE DRY Indoor 25ºC 30ºC 35ºC 40ºC 45ºC 50ºC Conditions Total capacity kW 2.04 1.94 1.61 1.53 1.41 21ºC D Sensitive capacity kW 1.52 1.41 1.39 1.32 1.19 1.07 15ºC W Input kW.
Page 16
WINTER OUTDOOR CONDITIONS 12ºC D 7ºC D 4ºC D 0ºC D -4ºC D -7ºC D Indoor 11ºC W 6ºC W 3ºC W -1ºC W -6ºC W -8ºC W Conditions Capacity kW 3.01 2.73 2.47 1.76 1.65 1.58 15ºC Input kW. 0.76 0.66 0.58...
Page 19
WINTER OUTDOOR CONDITIONS 12ºC D 7ºC D 4ºC D 0ºC D -4ºC D -7ºC D Indoor 11ºC W 6ºC W 3ºC W -1ºC W -6ºC W -8ºC W Conditions Capacity kW 4.446 4.264 4.132 3.838 3.335 3.305 15ºC Input kW. 1.141 1.106 1.059...
Page 22
7.2 Wiring diagram 7.2.1 Cooling only 7.2.1.1 MSC-07CRN1, MSC-09CRN1 MSC-12CRN1 IND OO R UNIT OUT DO OR UNIT 1 2(N) Y&G BLACK BLACK BLACK MOTOR BLUE BLUE Y&G COMPRESSOR CAPACITOR Downloaded from AC-Manual.com Manuals...
Page 23
7.2.1.2 MSC-18CRN1 INDOOR UNIT OUTDOOR UNIT Y&G BLACK BLACK OVERLOAD BLACK RELAY COMPRESSOR MOTOR BLUE WHITE BLUE COMPRESSOR CAPACITOR CAPACITOR Downloaded from AC-Manual.com Manuals...
Page 24
7.2.2 Heating/cooling 7.2.2.1 MSC-07HRN1, MSC-09HRN1 MSC-12HRN1 IND OOR UN IT OUT DOOR U NIT Downloaded from AC-Manual.com Manuals...
Page 25
7.2.2.2 MSC-18HRN1 INDOOR UNIT OUTDOOR UNIT BLUE BLUE Y&G 4-WAY BLACK OVERLOAD RELAY BLACK BLACK COMPRESSOR BLUE MOTOR WHITE BLUE COMPRESSOR CAPACITOR FAN CAPACITOR Downloaded from AC-Manual.com Manuals...
8 Electronic function Electric Control working environment 8.1.1 input voltage: 175~253V 8.1.2 Input power frequency:50Hz 8.1.3 Ambient temperature: -7°C~+43°C 8.1.4 Indoor fan normal working amp is less than 1A, 8.1.5 Outdoor fan. Normal working amp is less than 1.5A 8.1.6 Four-way valve normal working amp is less than 1A.
Page 27
Protection 8.4.1 3 minutes delay at restart for compressor. 8.4.2 Sensor protection at open circuit and breaking disconnection 8.4.3 Fan Speed is out of control. When Indoor Fan Speed is too high(higher than High Fan+300RPM)or too low(lower than 400RPM), the unit stops and LED displays failure information and can’t returns to normal operation automatically.
Page 28
Anti-freezing control to indoor evaporator at cooling mode( T: evaporator temp. ) Condition Compressor Outdoor fan Temp. Time Evaporator T> TE6 Temp. up T< TE6 >5 Minutes Evaporator T> TE5 Temp. down T< TE5 >5 Minutes Dehumidifying mode 8.7.1 The 4-way valve is off in dehumidifying mode 8.7.2 Compressor and Indoor Fan actions in dehumidifying mode Conditions...
Page 29
8.7.3 Low room temperature protection: When room temperature decreases to below 10℃, compressor and outdoor fan will stop(indoor fan is Breeze). Dehumidifying operation will be resumed when room temperature restores to over 13℃. 8.7.4 At dehumidifying mode, the anti-freezing function of the indoor heat exchanger is the same as that of cooling mode.
Page 30
8.8.6 Indoor evaporator high-temperature protection at heating mode Condition Compressor Outdoor fan T= Indoor exchanger temp. Indoor exchanger temp. up T<TE8 TE8<T<TE7 T>TE7 Indoor exchanger temp. down T>TE9 T<TE9 8.8.7. The louver opens to Standard Angle ANGLHEAT when power is on for the first time Defrosting operation (Available for heating only).
Page 31
8.9.4 Defrosting Actions: Defrost 10or 6minutes Compressor 4-way Valve Outdoor Fan Indoor Fan 8.10 Automatic operation mode 8.10.1 The air conditioner automatically selects one of the following operation modes: cooling, heating or fan only according to the temp. difference between room temp. (TA) and set temp. (TS). TA—TS Operation mode TA—TS>2℃...
Page 32
constant and the fan speed is kept at low speed. The total time is 7 hours, after 7 hours the unit stops. 8.14.3 Heating: The set temperature decrease 1℃ per hour. Two hours later, the set temperature will maintain as a constant and the air circulation is kept at low speed (Cold air proof function takes precedence over all).
9.Troubleshooting 9.1 Display board Signal receptor AU TO indicator Thi s indicator illuminates whe n the air conditioner i s in AUTO operation. DE FROST indicator (F or Cooling & H eating mo dels only) Thi s indicator illuminates whe n the air conditioner starts defrostin g automati cally or when the warm air control fea ture is activated in he ating oper ation.
Page 35
9.3 Diagnostic Chart 9.3.1 After energizing, no indicator is lighted and the air conditioner can’t be operated. After energizing, the air conditioner can’t be operated Check if AC220V power supply outputs to Indoor PCB. Check if AC220V exists at the primary coil of transformer. Indoor PCB is defective Check if AC14.5V exists at the secondary coil of transformer.
Page 36
9.3.3 Failure phenomenon Failure phenomenon Operation lamp Timer lamp Indoor fan speed has been out of control for over 1 minute ☆ Indoor room temp. or evaporator sensor is open circuit or short circuit ☆ Over current protection of the compressor occurs 4 times ☆...
Need help?
Do you have a question about the Corona MSC-07CRN1 and is the answer not in the manual?
Questions and answers