Chapter 1 Safety Precautions This chapter describes how to Safety Precautions. About Warning Descriptions ............4 Notes on Rack Mounting and Connecting a Powerstrip .
Safety and Installation Guide Chapter 1 Safety Precautions About Warning Descriptions This manual contains precautions that must be taken in order to use this device safely and prevent personal injury or property damage. Please fully understand the meanings and contents of the following descriptions and symbols when reading this manual.
Page 5
Fujitsu. Continuing to use the device in this condition may result in electric shock, fire accident or failure.
Page 6
Safety and Installation Guide Chapter 1 Safety Precautions Indicates that improper use can cause light or moderate injury. Caution In addition, this symbol indicates a chance of damage to this device and other connected equipment. Cautions Do not touch this device for more than one Avoid looking at the light source (e.g.
Safety and Installation Guide Chapter 1 Safety Precautions Notes on Rack Mounting and Connecting a Powerstrip If you mount this device on a rack, pay close attention to operation temperature management, Warning physical stability establishment and current leakage. This device must only be mounted on the rack by a qualified engineer with the required knowledge.
Chapter 2 Install ation This chapter describes how to install the switch. Requirements for Installation Environment ..........9 2.1.1 Installation Requirements .
Safety and Installation Guide Chapter 2 Installation Requirements for Installation Environment Before installing the switch, please check the following: • Make sure that the switch and all the other options shown in this document are available for installation. • All the cables comply with the specifications of the interface connectors. Warning Do not connect cables to interface connectors other than those adaptable to the connector’s specifications.
Page 10
Safety and Installation Guide Chapter 2 Installation Installation Condition Check List Check the following items. Check Item Check Result Nothing is put on the switch. Vents are not obstructed. The switch is not located on the table or not stuck on another switch. The switch is not located under direct sunshine, near heating appliance, under high humidity or in a dusty area.
Safety and Installation Guide Chapter 2 Installation Installation This section describes how to install the switch. 2.2.1 Installation of the Switch The following describes how to install. Installation on 19” Rack The switch can be installed and operated in the EIA standard 19” rack. Prepare the following rack mounting components attached.
Safety and Installation Guide Chapter 2 Installation Precautions When putting on rack mounting brackets, make sure to use special screws included in the 19” rack brackets set. If other screws are used, it may break. Also, make sure to use cross slot screwdriver corresponding to the screw thread. Fix the switch that rack mounting brackets are put at the procedure 2.
Page 13
Safety and Installation Guide Chapter 2 Installation Install the extension card slowly sliding on the guide rail inside the extension slot. Precautions Rightly install the extension card on the guide rail. If not, the connection pin may break. Fixed screw SFP+ module Firmly fix the extension card in the switch with the screw.
Page 14
Printed in Taiwan • The contents may be revised without prior notice. • Fujitsu assumes no liability for damages to third party copyrights or other rights arising from the use of any information in this manual. • No part of this manual may be reproduced in any form without the prior written permission of Fujitsu.