Boss BPS242RF Programming And Operating Instructions

Programming and operating Instructions for the BOSS BPS242RF
Programmable Room Thermostat
BPS242RF
Operating
Mode Slider
Batteries Compartment
Guide to symbols
on Operating Mode Slider
Automatic mode. The unit is controlling to the time and temperature programmes that have
been selected
Permanent comfort mode. The unit is controlling continuously to the comfort temperature
setpoint.
Permanent setback mode. The unit is controlling continuously to the setback temperature
setpoint.
Permanent standby mode. The unit is controlling continuously to the standby temperature
setpoint. This setpoint is fixed at 5°C
LCD Display
Time setting position
First switch on time
First switch off time
Second switch on time
Second switch off time
Comfort temperature setting
Setback temperature setting
Run position
Programming slider
Advance button
Rotary
Dial
Technical Helpline: 0870 850 0184
Guide to symbols
On LCD Display
Actual room temperature in °C
T
The unit is controlling to the selected comfort temperature setpoint
T
The unit is controlling to the selected setback temperature setpoint
T
The unit is controlling to the standby temperature setpoint
Indicates when the temperature setpoint has been moved from setpoint by user. This setpoint
will operate until the next switching time. This is only active when the controller is in the run
and automatic mode
Automatic mode. The unit is controlling to the time and temperature programmes that have
been selected
Permanent comfort mode. The unit is controlling continuously to the comfort temperature
setpoint.
Permanent setback mode. The unit is controlling continuously to the setback temperature
setpoint.
Permanent standby mode. The unit is controlling continuously to the standby temperature
setpoint.
Indicates there is a call for heat
Indication of low battery life, this signifies batteries must be replaced
Introduction.
This leaflet gives you easy to follow instructions on how to set up your BPS242RF programmable room
thermostat.
Contents
How do I set the time?
How do I set the switch on & off times?
How do I set the comfort temperature value?
How do I set the setback temperature value?
How do I temporarily change the current setpoint?
What does the Advance button do?