Do you have a question about the Refrigerator and is the answer not in the manual?
Questions and answers
thimmappa
March 10, 2025
not able to put freezer drawers back
1 comments:
Mr. Anderson
March 10, 2025
To reinstall a freezer drawer in a Samsung refrigerator, follow these steps:
1. Open the freezer door completely. 2. Insert the drawer into the frame rails. 3. Slide the drawer inward until it is fully seated.
For crisper drawers: 1. Remove door bins if necessary. 2. Insert the drawer into the frame rails. 3. Slide the drawer inward until secure.
For the FlexZone basket (if applicable): 1. Fully open the FlexZone drawer. 2. Place the FlexZone basket onto the frame. 3. Slide it inward until properly positioned.
Refrigerator user manual This manual is made with 100 % recycled paper. English imagine the possibilities Thank you for purchasing a Samsung product. Free Standing Appliance...
(including cover various models, children) with reduced the characteristics of physical, sensory or your refrigerator may mental capabilities, differ slightly from those or lack of experience described in this manual. and knowledge, unless they have been given...
Page 3
No 643/2009 of the European disassemble. Union. (For products sold in Represents something European Countries only) you must NOT touch. • This refrigerator must be Represents something properly installed and located you must follow. in accordance with the manual Indicates that you must before it is used.
Page 4
• Never start up an appliance electric shock or fi re. showing any signs of damage. • Do not place this refrigerator in If in doubt, consult your dealer. direct sunlight or expose to the • The room must be 1m3 in...
Page 5
• If the refrigerator is circuits, which could cause a disconnected from the power fi re hazard from overheated supply, you should wait for wires. at least ten minutes before plugging it back. • Make sure that the power plug is not squashed or damaged by •...
Page 6
- This may cause frostbite. recommended by the • If the refrigerator is not to be manufacturer. used for a long period of time, • Do not damage the refrigerant pull out the power plug.
Page 7
• Products that require strict • Do not overfill the refrigerator temperature controls must not with food. be stored in the refrigerator. Do not put a container filled with - When you open the door, an water on the refrigerator.
Page 8
However, you should minimize the number of • Leave the shelves in place so...
Page 9
• There is no need to disconnect please wrap the frozen food in the refrigerator from the power several layers of paper such as supply if you will be away for newspaper.
Page 10
- Allow warm food to cool down fi ttings such as baskets, drawers, before placing it in the appliance. shelves on the position supplied - Put frozen food in the refrigerator by manufacturer. to thaw. You can then use the low...
Screw Driver supply. When installing, servicing or cleaning behind • Select a location without direct exposure to the refrigerator, be sure to pull the unit straight CAUTION sunlight. out and push back in straight after fi nishing. • Select a location with level (or nearly level) flooring.
USING THE ICE MAKER SETTING UP THE REFRIGERATOR DOORS To Remove the Ice If your entrance won’t allow the refrigerator to pass Bucket easily through it, you can remove the doors. - Hold the handle as shown in figure1. Removing the Front Leg Cover - Slightly pull up the bottom part.
• Make sure that you lift the door straight up so the hinges are not bent or broken. • Be careful not to pinch the water tubing and wire Be careful not to miss the parts of refrigerator. harness on the door. • Place doors on a protected surface to prevent scratching or damage.
2. Remove hinge screws and the ground screw by turning counter-clockwise, and take off the Now that the doors are back on the refrigerator, you want to make sure the refrigerator is level so that upper hinge . Be careful that the door does not you can make fi...
Page 15
When you turn clockwise , the door will TO THE DOORS move up. Remember, a levelling refrigerator is necessary 3. After adjusting the doors, turn the nut for getting the doors perfectly even. If you need clockwise until it reaches the lower end...
4. After connecting the water supply to the water seconds. filter, turn your main water supply back on and If the refrigerator is installed in an area with low water Dispense about 3L to clear and prime the water pressure (below 138 kPa), you can install a booster filter.
Page 17
Before being used, the leakage in these places should be examined CAUTION • Samsung Warranty does not cover WATER LINE INSTALLATION. • It’ll be done at customer’s charge unless the retail price includes installation cost.
When you change the filter, press and hold this button for 3 seconds to reset the filter schedule. you do not need to use the refrigerator, press and hold the Child Lock button for 3 seconds. The Press the Lighting button for the dispenser LED Lighting lamp to stay on.
LIGHTING CHILD LOCK This icon will light up when you activate the This icon will light up when you activate the Child “Lighting” feature. In this case, the dispenser light Lock function by pressing Child Lock button. (under the display) will be on constantly. If you would Press this button again to reactivate.
When Cubed Ice is selected after using the Crushed This may cause the digital display to blink. Once Ice feature, a small amount of residual crushed ice the freezer and refrigerator return to their normal set might be produced. temperatures the blinking will stop.
Page 21
• If you have a long vacation or business trip For more space, you can and won’t use water or ice dispensers, store food with Guard CAUTION close the water valve. FRE-UPP instead of the - Otherwise, water leakage may occur. ice bucket ( ...
Page 22
The drawer digital panel shows the same temperature When “Chill” is selected, the temperature as that of the refrigerator display panel. Since the of the CoolSelect Zone™ Drawer is “Cool” function mimics the refrigerator temperature, kept at -1°C, regardless of the overall...
Remove the Drawer by pulling it appliance and may cause a fi re. out and slightly lifting it up. Do not spray the refrigerator with water while it is plugged in, as it may cause an electric CAUTION shock. Do not clean the refrigerator with benzene, thinner or car detergent for risk of fi...
USING THE DOORS about every 6 months. 2. Remove the new filter’s protective cap and remove The refrigerator doors are equipped with a door the old filter. opening and closing feature that ensures that the 3. Position and insert the new filter into the filter doors close all the way and are securely sealed.
You hear unusual noises • Check that the refrigerator is level and stable. or sounds. • Is the back of the refrigerator too close to the wall and therefore keeping air from circulating? • Was anything dropped behind or under the refrigerator? •...
Page 26
• Has the water supply line tubing been crushed or kinked? Make sure the tubing is free and clear of any obstruction. • Is the water tank frozen because the refrigerator temperature is too low? Try selecting a warmer setting on the main display panel.
Page 28
This product and its electronic accessories should not be mixed with other commercial wastes for disposal. Contact SAMSUNG WORLD WIDE If you have any questions or comments relating to Samsung products, please contact the SAMSUNG customer care center. COUNTRY...
Need help?
Do you have a question about the Refrigerator and is the answer not in the manual?
Questions and answers
not able to put freezer drawers back
To reinstall a freezer drawer in a Samsung refrigerator, follow these steps:
1. Open the freezer door completely.
2. Insert the drawer into the frame rails.
3. Slide the drawer inward until it is fully seated.
For crisper drawers:
1. Remove door bins if necessary.
2. Insert the drawer into the frame rails.
3. Slide the drawer inward until secure.
For the FlexZone basket (if applicable):
1. Fully open the FlexZone drawer.
2. Place the FlexZone basket onto the frame.
3. Slide it inward until properly positioned.
This answer is automatically generated