Page 3
Dear Costumer, You have just acquired a BRANDT washing machine and we would like to thank you. We have invested all our dedication and know-how in this appliance so that it would best meet your needs. With innovation and performance, we designed it to be always easy to use.
Page 5
WARNINGS SPECIFICATIONS INSTALLATION AND ASSEMBLY USING THE APPLIANCE AND PRACTICAL TIPS MAINTENANCE AND CLEANING SAFETY AND TROUBLESHOOTING ENVIRONMENTAL NOTICE...
Page 6
Do not repair or replace any parts of the This appliance is not designed to be used washing machine, and do not carry out any by physically, sensorially or mentally maintenance operations on the appliance...
Electric cable Control panel Detergent dispenser Drain Drum hose Loading door Accessible filter (behind the plinth) Plinth Levelling feet ACCESSORIES Water supply hose...
UNPACKING AND UNBLOCKING THE WASHING MACHINE UNPACKING a Remove the base, the corner pieces and the top protection cover. UNBLOCKING a Unscrew the screws holding the 3 plastic cover pieces in place, at the rear of the washing machine.
Page 9
Make sure you connect the elbow of the water supply hose correctly, to avoid any risk of flooding. If your washing machine allows for connection to a hot water supply intake, connect the red grooved tube to the hot water tap and the water valve to the red filter.
For built-in washing machines, the mains Never plug the washing machine into the connection plug must be accessible after mains with wet or damp hands. installation.
Page 11
PRE-CLEANING PRE-CLEANING When your washing machine has been correctly installed, we recommend that you pre-clean the machine. This is to check that the installation, the connections and the drainage are all correct, and to thoroughly clean the inside of the...
Page 12
Sort the clothes by colour Wash whites and coloureds separately. We recommend you load your washing machine to the maximum level, to economise on water and power. We advise washing items of different sizes together whenever possible, as...
Before washing, place the detergent and additives in their corresponding compartments. c You can also use liquid detergents in the washing machine. To do this, use the optional compartment, which you can acquire by contacting the Technical Assistance Service.
To select a wash programme, proceed as follows: a Starting from the “Stop” position, the washing machine will switch on when you select the desired wash programme (see programme chart). b The “Stop” pilot light will start to flash...
Page 15
using the appliance and practical tips To select the drying time, proceed as follows: a Select the drying time in minutes by pressing the drying time button. The duration will appear on the display. Press this button several times to progressively increase the drying time.
Option buttons Recommended Programme Fabric type Temperature Cotton/Linen Cotton + Prewash 60ºC white/fast colours heavy soil Cotton/Linen Cotton 90ºC YESI white heavy soil Cotton/Linen Cotton 60ºC fast colours medium soil Cotton/Linen Cotton 40ºC fast colours light soil Cotton/Linen 5 (*) Cotton 30ºC delicate colours light soil...
Page 17
Approx. Max. Detergent Programme Total consumption Duration Load Description (kwh/litre) compartment (minutes) (kg) Prewash, standard wash, rinses, automatic additive absorption 1,45/60 if required and long final spin 1,90/55 1,02/49 Standard wash, rinses, automatic additive absorption if required and long final spin 0,65/49 0,40/49 2,8/48...
FULL TUB STOP The wash programme stops on the last rinse, with the clothes left in water. When the function is deactivated, the washing machine continues the programme, draining and spin-drying. It is used, for example, when you are not at...
Page 19
Increases water consumption! START/PAUSE To start up your washing cycle, press the Start/Pause button. SWITCH OFF Turn the programme selector dial to “Stop” to switch off the washing machine.
Page 20
This protects the washing machine from If a power cut should occur, when the electricity vibrating excessively. If you notice that the comes back on the washing machine will clothes are still too damp after spin drying, continue functioning from where it left off (it distribute them evenly inside the drum and has a memory of several hours).
This will prolong the life of your washing machine. Unplug the washing machine from the mains before carrying out any cleaning or maintenance operations. CLEANING THE DETERGENT DRAWER...
30ºC. CLEANING THE OUTSIDE To clean the outside of the washing machine, If any detergent or additives from the use warm soapy water or a gentle cleaning detergent drawer are spilt onto the product.
The washing machine will Check the door is properly closed. not start up The washing machine is not plugged into the mains, or there is no electricity supply. The Start/Pause button has not been pressed. If the washing machine door is not properly closed, F04 will appear on the display.
Page 24
Solution: Redistribute the clothes evenly and run a spin dry programme. If this failure occurs, C3 will appear on the display. The washing machine is provided with an environment- I cannot see any water in the friendly system able to adapt to the load and type of fabrics, drum during washing adjusting the levels of water and energy used.
Page 25
Today’s washing machines are equipped with user safety Why can’t I open the door systems. The washing machine door cannot be opened if as soon as the wash the drum has not totally come to a halt. You therefore need programme ends? to wait around 2 minutes before you can open the door.
The packaging materials for this appliance can be This will help your manufacturer to correctly recycle recycled. If you recycle them, you will contribute their appliances, in compliance with European to protecting the environment. Please place them...
Page 52
2/F., Shing Dao Industrial Building, 2418 3246 232 Aberdeen Main Road, Hong Kong 8210 8210 Product Information 2418 3246 Service Hotline 8210 8210...
Need help?
Do you have a question about the Washing machine and is the answer not in the manual?
Questions and answers