Programming Mode (T 1576 Only); Table 6-3: T 1576 Fault Codes - Miele T 15xx Technical Information

Technical Information
The “"Anti-crease”" LED is FLASHING - Fault stored. Proceed to “"Access”"
steps below.
Access (retrieval):
1. Access the service mode. See Section 6.1.2.
2. Turn the selector switch to “"Woolens”".
3. Press the Start button.
4. Note the illuminated LEDs.
5. Refer to Table 6-3 to determine the stored fault.
6. Switch the appliance off.
7. Perform the necessary service steps to rectify the cause of the fault, then
proceed to “"Delete a Stored Fault Code”" below.
LED(s) Lit Steadily
Rotary iron
Hand iron
Normal
Rotary iron & Hand iron
Normal and Rotary iron

Table 6-3: T 1576 Fault Codes

Delete a stored fault code:
1. Access the service mode. See Section 6.1.2.
2. Turn the selector switch to “"Woolens”".
3. Press the Start button.
4. Press and hold the Gentle button.
5. Press the Start button.
6. Release the Gentle button. The appropriate LED turns off.
7. Switch the appliance off.
6.3

Programming Mode (T 1576 Only)

Accessing:
1. Switch the appliance off.
2. Turn the program selector switch to 12 o’'clock.
3. Press and hold the Gentle and Buzzer buttons.
4. Switch the appliance on.
5. Release the buttons.
Acknowledgement indicator:
The “"Drying”" and “"Cooling down”" LEDs flash to indicate that programming mode
is active.
Navigation:
1. Turn the program selector switch to the desired position; press Start to
activate the function.
2. The programmed option is indicated by the status of the “"Rotary iron”" LED.
Component
Fan NTC open circuit
NTC at heater bank open circuit
NTC at heater bank short circuit
Fan NTC short circuit
Maximum drying time (180 minutes) exceeded
38
T 15xx Dryers