Direct Console Access; Telnet Console Access - HP ProCurve 10 Installation Manual

Installing the HP 10/100 Hubs
Installation Procedures

Direct Console Access

To connect a console to the
hub, follow these steps:
1.
2.
3.

Telnet Console Access

To access the hub through a telnet session, follow these steps:
1.
2.
3.
If you want to continue with console management of the hub at this time, refer
to the HP ProCurve 10/100 Hub 12M and Hub 24M Management and
Configuration Guide that came with your hub.
2-12
Connect the PC or
terminal to the hub's
Console Port using the
console cable included
with the hub. (If your PC
or terminal has a 25-pin
serial connector, first
attach a 9-pin to 25-pin
adapter at one end of the
console cable.)
Turn on the terminal or
PC's power and, if using a
PC, start the PC terminal
program.
Press [Enter] two or three times and you will see the hub identification
information and the message "Press any key to continue". Press a key, and
you will then see the hub console commands.
Make sure the hub is configured with an IP address and that the hub is
reachable from the telnet workstation (for example by using a Ping
command to the hub's IP address)
Start the telnet program and connect to the hub's IP address.
You will see the hub identification information and the message "Press
any key to continue". Press a key, and you will then see the hub console
commands.
console port
console cable supplied
with the hub
PC running a terminal
emulator program, or
a VT-100 terminal