Flowcontrol Receive - Dell Networking 2024 Reference Manual

Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet,
fortygigabitethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds a description to the Ethernet port 5.
console(config)#interface gigabitethernet 1/0/5
console(config-if-Gi1/0/5)# description RD_SW#3
duplex
The duplex command is deprecated.

flowcontrol receive

Use the flowcontrol command in Global Configuration mode to configure
the flow control. To disable flow control, use the no form of this command.
Syntax
flowcontrol receive {on | off}
no flowcontrol receive
Default Configuration
Flow Control is enabled by default.
Command Mode
Global Configuration and Interface Configuration modes
User Guidelines
Dell Networking switches implement receive flow control only. They never
issue a flow control PAUSE frame when congested, but do respect received
flow control PAUSE frames received from other switches. Disabling flow
control causes the switch to ignore received PAUSE frames.
374
Ethernet Configuration Commands