Page 1
The cabinet opening should be square. You should be able to fully open the compactor drawer. Six inches (15.2 cm) of clearance is needed on the right side of compactor drawer to be able to remove compactor bag.
Page 2
Tools and materials needed for instaIIatSon: Parts supplied for undercounter instaIIat3on: 1 LH retaining bracket 1 RH retaining bracket 2 retaining bracket screws #8 x 5/16 2 mounting clips 2 mounting screws #8 - 18 x 112 All parts are in literature package in drawer, Page 2...
Page 3
Go to Step 9. Undercounter installation Remove the plastic plugs from the compactor top. Determine if you want the compactor frame or drawer front flush with the cabinet front. Install the retaining brackets cabinet top to one position: If the compactor...
Page 4
Freestanding installation Carefully move it into its final position. Check that compactor is still level (See Step 7.) Go to Step 11, Undercounter installation Carefully lift the front slightly and roll it into the cabinet...
Page 5
Step 11 of Installation Instructions.) 22-15/16” (58.3 cm) :y... ,4-5,*” .--j::: (37.2 cm) Figure 4 Before you call for service... If your compactor does not operate properly, check the following before calling service - If the compactor won’t operate: Is the power supply cord...
Page 6
Yellow Pages of your phone directory under “Appliances - Major”. When you call, you will need the compactor model number serial number. Both numbers on the serial/rating plate, which can be found by pulling...
Need help?
Do you have a question about the compactor and is the answer not in the manual?
Questions and answers