How To Charge The Battery; Quick Start Guide - FLIR Extech i5 Getting Started Manual

EN-US English

How to charge the battery

You must charge the battery inside the
camera for four full hours (or until the
battery indicator displays a green light)
before you use the camera for the first
time.
Charge the battery by connecting the
power supply to the power connector on
the camera. Note: The first time you
charge a factory-new battery you must
turn on and then turn off the camera after
you have connected the power supply to
the power connector on the camera.
1. Battery indicator
2. Power supply cable

Quick Start Guide

Follow this procedure to start
immediately:
1. Remove the protective film from the
LCD.
2. Insert a miniSD™ Memory Card into
the card slot.
20
3. Push the On/Off button to turn on the
camera. Note: If the camera does not
start, push the reset button with a
non-conductive tool. The reset button
is located beside the battery
connector, inside the battery
compartment. Then push the On/Off
button again.
4. Open the lens cap by pushing the
lens cap lever.
5. Aim the camera toward your target of
interest.
6. Pull the save trigger to save the
image.
7. To move the image to a computer, do
one of the following:
© 2010, FLIR Systems AB. All rights reserved worldwide.
Publ. no. T559169, rev. 003