Replacing The Toner Cartridge - Sharp AR-6020 Operation Manual

REPLACING THE TONER CARTRIDGE

When the toner cartridge replacement required indicator (
soon. Obtain a new cartridge. When the toner cartridge replacement required indicator (
cartridge must be replaced before copying can be resumed.
Replace the toner cartridge by following the procedure below.
Note
When the toner cartridge replacement indicator (
1
Push on both ends of the front cover
and open it.
2
Pull the toner cartridge out while
pressing the lock release lever.
Toner cartridge
lock release lever
After removing the toner cartridge, do not
Caution
shake it or tap on it. Doing so may cause
toner to leak from the cartridge. Put the old
cartridge immediately in the box. Dispose of
the old toner cartridge in accordance with
local regulations.
3
Remove the new toner cartridge.
Grasp the cartridge on both sides and
shake it horizontally four or five times.
4 or 5 times
Grasp the grip when holding the cartridge.
Caution
When pulling out the
toner cartridge, place
your other hand on the
indentation of the
cartridge.
) lights up, the toner cartridge will need replacement
) lights up, little toner remains and thus copies may be faint.
4
Insert the toner cartridge along the
guides until it locks in place while
pushing the lock release lever.
5
Close the front cover.
• Even after a new toner cartridge is
Note
installed, the toner cartridge replacement
required indicator (
indicating that copying cannot be resumed
(toner is not fed sufficiently). In this case,
open and close the front cover.
The machine will feed toner again for about
two minutes and then copying can be
resumed.
• Before closing the front cover, make sure
that the toner cartridge is correctly installed.
• When closing the front cover, gently hold
both ends.
) blinks, the toner
If there is any dirt or dust
on the toner cartridge,
remove it before
installing the cartridge.
The toner cartridge
replacement required
indicator ( ) will go
out.
) may still light up,
119
7