OPTO 22 PCI-AC51 User Manual page 32

ERROR CODES FOR WINDOWS 2000/XP
Code
Decimal
8198
8199
8200
8201
8202
8203
8204
8205
8206
8207
8384
8385
8386
8387
28
PCI-AC51 User's Guide
Code Description
Hex
Could not acquire access
0x2006
to B6 DPRAM
Power-up clear /B6
0x2007
needs configuring
B6 didn't update – PC
0x2008
polling too quick
Watchdog timeout has
0x2009
occurred
Wrong OptoPMux DLL
0x200A
(trying to open ISA card)
Board ID doesn't exist in
0x200B
system
A closed handle tried to
0x200C
be used
A handle number out of
0x200D
range tried to be used
Specified device is
0x200E
already open
Registry entry does not
0x2010
exist.
Specified PCI board ID
0x20C0
was not found.
The device layer was not
0x20C1
found.
The device layer file ver-
0x20C2 sion is too old for the
SDK.
OptoPM32 does not sup-
0x20C3
port this function.
Remedy
The attempt to gain access to the B6 or SNAP-B6 analog
memory failed. This is not an error; it may mean that the
brain was involved in reading and writing to this memory
array.
The B6 or SNAP B6 was recently powered up due to a
manual power enable or from a power dip event, causing
the brain to reset. This brain may require special reconfigu-
ration.
The rate of the PC's polling is very fast. This is not an error.
It only indicates that the application should be modified to
decrease the analog scan intervals. This code may be
seen on faster CPU computers.
The brain reports a watchdog timeout. This is caused when
a communication cycle to the bus exceeds the watchdog
timeout time.
This error indicates that a call was made to a function that
is not currently supported in this version of the
OptoPM32.DLL.
The PCI board number matching the Opto 22 vendor ID
(0x148A) and device ID (0xAC51) could not be found.
Remember that board IDs start from zero and end at "n-1"
(where n is the number of boards).
The handle that was sent to this function is closed. This
may represent corruption of the handle, failure to success-
fully open the handle, or a PamuxPCICardClose may have
been previously executed on this handle.
The handle submitted is invalid, as it is beyond the number
of handles the OptoPM32.DLL supports. Inspect the han-
dle for corruption. Also, validate that the handle number
does not change when PamuxPCICardOpen opens a valid
handle. It is also possible that an incorrect argument is
being passed to the function.
When inspecting the opening of a PCI-AC51, the handle's
data structure is marked as open. The OptoPM32.DLL
does not support multiple access handles to individual
PCI-AC51s.
A historic WinRT error that doesn't apply to the
OptoPM32.DLL.
The board ID is beyond the range of valid board ID num-
bers. The range is always from zero to one less than the
number of adapters installed in the computer.
The customer application is copied onto a system that
does not have the SDK layer installed.
May happen if a SDK with an older WinDriver version is
installed onto the system. Update all SDK installations with
the latest SDKs.
An unsupported PCI-AC51 function is called from the appli-
cation. The PCI-AC51 does not support the identify type
and does not support a reset level function.