Delete All Programs; Reset System Setting; Firmware Update Via Usb; System Setting - Ferguson FT-8300 HD User Manual

1.3 Delete All Programs

This operation will irreversibly delete all programs from receiver.

1.4 Reset System Setting

This operation removes any changes made by the user. The receiver will return to its factory settings.
Upon completion of this operation receiver will automatically be rebooted.

1.5 Firmware Update Via USB

Warning: Do not turn off the power during the update. This risks lasting damage to
equipment.
6. Once the progress is 100%, please power off STB and pull out USB disk, then restart your STB again.
7. Please check the software version in the System Information->SW/HW Information.

2. System Setting

2.1 Audio Setting

2.2 Video Setting

Once you get the right file from your franchiser, please upgrade
software as following steps:
1. Format your USB disk to FAT32 file system and copy image.dat
to USB disk;
2. Power off receiver and pull out antenna
3. Insert USB disk to receiver's USB port
4. Power on STB, and then enter into Installation->Firmware
update via USB.
5. Then the system will check the USB device and upgrade
software by itself. If successful, the menu will display the progress
of updating .
User can choose below options of volume control:
Digital output mode: PCM or AC3.
Sound track: Left, Right or Stereo.
Volume control mode: United or Single.
Language chooses: Primary Language and Second Language.
User can choose below options of video control:
Aspect ratio: 4:3 or 16:9.
Screen Format: Full screen, LetterBox or Pan&Scan.
Resolving: 1080i or 720p.
TV system: Auto, NTSC, SECAM or PAL.
12