Troubleshooting - 3M Scotch-Weld Hot Melt Applicator EC Owner's Manual

Troubleshooting

WARNING
!
Use only 3M-specified replacement
parts. Use of other replacements
parts may cause hazardous
conditions or damage the
applicator.
15
This part of the owner's manual is divided into three sections to assist in
evaluating possible operating difficulties with your 3M™ Scotch-Weld™
Hot Melt Applicator EC.
If the applicator will not heat, refer to:
Condition 1:
Applicator will not heat
If the applicator is heating, refer to:
Condition 2:
Dripping nozzle
Condition 3:
No or low adhesive flow
An applicator diagram and replacement parts list can be found on pages
26-27. Should your applicator require repair, replacement parts can be
ordered from your local authorized 3M Scotch-Weld Hot Melt Adhesive
distributor. If, after following these procedures, a problem still exists,
contact your local Sales Representative. For telephone numbers of the
nearest 3M location refer to the back cover of this manual.
Service on this applicator should only be performed by a qualified
electrician or service person.
Important:
Page 16
Page 22
Page 24
© 3M 2006