Troubleshooting; Assistance Or Service; Replacement Parts - Whirlpool GAS FURNACE User Instructions

Filter Location - Upflow Models (Bottom Return)
1. Side
2. Base
If the furnace has a bottom return air, remove the lower front
panel by lifting up and pulling out. The filter(s) may be removed
by lifting up and sliding toward the front. Replace in a reverse
procedure.
Filter Location -Counterflow Models and
Horizontal Models
The filters in counterflow furnaces are typically placed by the
installer into the return plenum of the furnace.

TROUBLESHOOTING

First try the solutions suggested here and possibly avoid the
cost of a service call.
Unit fails to operate
Check the following:
Is the main switch that supplies power to the unit in the ON
position?
Has a fuse blown or has the circuit breaker tripped? If
problem continues, call an electrician.
Is the thermostat set properly? See "Adjusting the Controls."
Unit is operating but not providing complete comfort
Check the following:
Is the thermostat set properly? See "Thermostat Control."
Is the filter clean? Replace or clean filter. See the "Filter
Maintenance" section.
Is the air able to circulate freely throughout your home? Do
not block supply registers or return grilles with furniture
or rugs.
6
1
2
3
4
3. Filter
4. Front

ASSISTANCE OR SERVICE

If you need further assistance, you can write to the below
address with any questions or concerns:
Whirlpool ® Home Cooling and Heating
7901 Southwest 6th Street
Plantation, FL 33324
Please include a daytime phone number in your correspondence.

Replacement Parts

To order replacement parts contact your Whirlpool
Cooling and Heating dealer.
Gas Control Group
Manifold
Burner
Orifice
Heat Exchanger Group
Primary heat exchanger
Secondary heat exchanger (if used)
Condensate drain pan (if used)
Blower Group
Blower housing assembly
Blower wheel
Blower motor
Inducer Group
Pressure switch
Electrical Group
Limit control
Blower control
Transformer
® Home
Flame sensor
Gas valve/Ignition control
Hot surface igniter
Blower motor mount
Capacitor
Inducer blower
Rollout switch
Auxiliary limit (if used)
Blower door interlock
switch