Introduction Before you set out / Hitching the COMBI-CAMP Opening and final adjustment Integrated sun canopy / awning Sun Canopy as kitchen canopy Accessories to the trailer tent Kitchen 12-13 Maintenance 14-15 Storage / Technical data 16-17 GUARANTEE...
Page 3
This booklet has been created to help you get the optimum from your COMBICAMP trailer tent, and we advise you to read it carefully. Get to know your COMBI-CAMP at home - erect the trailer tent a few times, so that you have good knowledge of what to do before you...
B e fo r e y o u se t o ut Check points: • Heavy items should be placed • Close and securely lock all locks on the axle line even if only the on trailer and kitchen roof rack is used. Be aware of the • Check the proper function of all added weight if a kitchen is later road lights before you start your fitted and adjust the balance trip. accordingly. The weight at • It is important to tighten wheel nuts the hitch should be between 44- after driving the first 200 Km. 110 pounds (20 to 50 Kg.). • If your COMBI-CAMP is equipped • Do not place luggage too close with brakes, they must be adjusted to the outer walls of the trailer - after driving the first 200 Km. there must be 8 inches of space • Check your tyre pressure. Loads up left to accommodate the tent and to 500 kg 20 PSI - 1.5 BAR. Loads frames. This will ensure proper up to 750 kg 30 PSI - 2.1 BAR.
Page 5
H i t c h i ng the C OM BI-CAMP Trailers with brakes: Trailers without brakes: • The handle is, in the upper • The handle is in the upper position position i.e. open, then the hitch is and kept here whilst the hitch is lowered by using the jockey wheel lowered by using the jockey wheel on to the vehicles tow bar. on to the vehicle’s tow bar. • When the hitch is lowered the handle will go into normal position. • When the hitch is in the correct • To unhitch the trailer, lift the position, the green indicator on the handle and turn the jockey wheel front of the handle to dismount the COMBI-CAMP. hitch will be visible and the handle will automatically move to the normal position. • Remember to attach the safety Light cable, which activates the brakes • Always remember: the trailers, in case the trailer becomes detac electrical plug must be inserted to hed from the tow bar. the vehicle. See diagram page 19.
Page 6
O p e n in g the tra i ler a n d e re c ti ng th e tent • Opening the trailer tent should be carried out on a fairly level site. • Remember it is not recommendable to place the trailer under trees. Objects can fall down and eventually damage or discolour the tent canvas. Fig. 3 • Now open the top of the trailer (Fig. 3), pull it towards and past the position of the roof rack and further until it reaches the ground. Fig. 1 Never use the roof rack as a lever. Walk into the tent and push up the • When the COMBI-CAMP is unhitched two connecting and placed on the desired poles on the spot, using the front support leg or...
O p e n in g an d f i na l adju stment • Finally the outside vent can be opened. Zip up and place the fibreglass section into the sleeve and bend the section and insert into the pocket in the other side. • Pull the rain protection skirt out over the trailer and adjust the nylon skirt over the floor edge. • All windows are complete with ventilation panels fitted with mos- quito nets. Should you wish ventila- tion role the canvas part to the side and tie. Should it rain, the panel can be opened just a little with use of a guy rope into the “D” ring located at the bottom of the panel. ...
• The height is all force is reduced from the tent adjusted on the canvas and two legs. Adjust the integra- the integrated ted frames frames and lock can move the black freely. adjuster (Fig. 7) The canvas is now zip- ped on to the COMBI-CAMP Fig. 7 • The sun • The side can canopy is now be pegged put on or rolled back top of the to the trailer. integrated frames, whilst they are pulled out. Both the • Sun canopy frames 22 mm and 19 mm fully erected. are pulled out, such as the little pressure spring is engaged into the 22 mm frame and this is pulled out ¾ way.
Page 9
I n t eg ra ted su n cano py/aw ning • The small elastic can easily be attached to the awning “D” rings. • The draught skirt is fitted below the kitchen. When closing the trailer down, to save time you may leave the sun canopy attached and stored on top of the trailer roof. Important - when closing the integrated frames they must be pushed all the way back.
S u n C an o py as ki tc hen canopy Sun Canopy as kitchen canopy: and the frame is inserted into the small grey PVC pockets. • If you are having a one night stop, for ease you can move the integrated frames halfway out and fold the rest of the roof below the canopy roof. Please note that the canopy must be on top of all frames. • When the sun canopy is still on top of the trailer, pull out the 19 mm frame approx. 10 cm (4”) until the pressure spring becomes visible • Hereafter pull out the 22 mm frame The frame’s a pprox. 1m (3’4”) adjusters are tightened and the loose hanging sun canopy is tightened to the trailer body canvas by using the ribbons.
A c c e s so ri es to the traile r tent Fitting the annex: • The detachable side of the trailer’s body canvas is zipped out. • The annex cabin is zipped in. • The poles with the accompanying two round corners are put into the sleeve inside the annex. • The support poles with hook end are put into the two holes in the trailers steel section at the floor. • The last two support poles can then be placed between the roun- ded corners and the annex floor. • The nylon floor of the annex is then stretched and pegged all the way round, do not over tighten. • Finally place the fibre glass pole inside the ventilation flap, where after the inner tent is fitted. The door canopy is fitted as...
k i t c h en Frigde Before using your fridge: Liquid gas operation • Cleaning of the fridge. • Regulator "B" is pressed down Before using the fridge you and kept in this position for 10 should clean the inside and out seconds.
Page 13
k i t c h en at the right top corner of the Fitting the regulator fridge. The regulator is pressed to gas bottle down some 20-25 seconds longer Screw the regulator on to the to activate the automatic ignition bottle until tight.The regulator safety devise, which then controls is open when in position “O” and the gas supply. closed in position “F”. • When the desired temperature is reached regulator "B" is turned The water tap backwards towards position "MIN" The water tap is electrically ope- • Remember to cut the gas supply rated and should be powered by when the refrigerator is no longer two batteries placed into the bat- running on gas. tery box behind the lower plastic drawer.Two batteries type 4R 25, Gasburners 6 volts should be used.They are The kitchen has three burners that not supplied. When the water tap function in the following manner: is turned on, the pump in the water • Open the gas supply tap.
M a i n t en a nc e Be good to your COMBI-CAMP, this will serve both you and your COMBI-CAMP best.A reasonable maintenance will ensure you a reliable trailer tent for many years to come. The tent Wheel / Axle / Hinges • The COMBI-...
Page 15
All our cotton tent canvases are opened against the ground. designed “ shrink to fit”. Do not fold down the tent before We recommend that the bottom of it is absolutely dry. the trailer is sealed with rust proofing material. Before the first trip: The tent canvas is made from a When you open your COMBI-CAMP natural cotton product. Should you for the first time,we strongly experience a slight leak around the recommend that the tent canvas is stitching of the canvas this can be sprayed with water. Even the finest...
Page 16
• See that the trailer and tent are completely dry before storage. • You are well advised to remove mattresses as well as the inner tent and store in a totally dry spot during the winter. • If storage space is limited the COMBI-CAMP can be stored on it’s side by means of the optional side storage legs. Such legs are available from your local COMBI- CAMP dealer. Puncture/ Spare wheel • Should you experience a punc ture with your COMBI-CAMP, both the front jack leg or jockey wheel if fitted as well as the rear sup port legs can be used as jacks. We advise you to purchase a spare wheel before you go camping travelling. U s e fu l h in t s , w o r t h r e m e m ber ing • Table and chairs...
t e ch ni c a l d ata 4160 1692 3372 1998 1250 2700 1270 2450 Net weight: 450 kg Gross weight: 750 kg 4160 1692 3051 1998 1258 Valley Valley 2900 1260 2450 Net weight: 350 kg with overrunning brakes: 375 kg Cross weight: 750 kg All dimensions i mm F i tt i n g i n s tr u c t io N for 7 P i n pl ug ( 12N) or 13 Pi n pl ug...
General conditions of guarantee All COMBI-CAMP models are guaranteed for 12 months as regards materials, workman-ship and/or defects that can be traced back to the factory. Normal wear and tear and tyres, tubes etc. are not covered by the guarantee. The guarantee takes effect as from the date of delivery. Duly completed. The guarantee shall not be valid if our direc- tions for use and maintenance are not strictly observed. www.combi cam p .c om...
Need help?
Do you have a question about the Trailer and is the answer not in the manual?
Questions and answers