Panasonic WV-SW396A Installation Manual page 14

When noise disturbance may happen
Conduct the power distribution work to keep a distance of
1 m {3.28 feet} or more from the 120 V (for U.S. and
Canada) or 220 V - 240 V (for Europe and other countries)
power line. Or conduct the electric conduit work sepa-
rately.
Radio disturbance
When this product is used near TV/radio antenna, strong
electric field or magnetic field (near a motor, a transformer
or a power line), images may be distorted and noise
sound may be produced.
Take notice of humidity.
Install this product when the humidity is low. If this product
is installed during rainfall or at a high humidity, the inside
may be exposed to moisture and the dome cover may
become foggy.
Heater unit
This product is equipped with an internal heater unit for
use in cold climates. When connected with a PoE+ hub/
device, the product can operate in an environment below
–30 °C {–22 °F}. When connected with the 24 V AC
power supply, the product can operate in an environment
below –50 °C {–58 °F}*
{–40 °F}
SW395A
automatically when the temperature inside the product
drops below +10 °C {50 °F}. However, in an extremely
low-temperature environment below –30 °C {–22 °F},
snow and frost may not be defrosted from the dome
cover. When using the product in cold climates, take
notice of the ambient and internal temperatures of the
product.
When this product is installed and operated in low tem-
peratures below –10 °C {14 °F}, normal images may not
be obtained immediately after startup. In such a case, wait
around 2 hours or more, and turn on the power again.
* When using this product at temperatures of –40 °C
{–40 °F} or below, use the power supply between 24 V
AC and 27 V AC. SW396A
Influence on images and their quality
This product has no wiper unit. Under the following condi-
tions, image quality may deteriorate or images may not be
viewed properly.
(1) Influence by rainfall
Due to the wind that accompanies rainfall, images
may be less viewable.
(2) Influence by snowfall
Due to the wind that accompanies snowfall, snow
may fall on the dome cover. That may partially make
surveillance images inviewable. (The extent of inview-
ability may vary depending on the amount of snowfall
and the quality of snow.)
14
SW396A SW396
SW395 . The heater unit turns on
SW396
(3) Influence by dust in the air or gas emission from vehi-
cles
Depending on the installation environment, dome
cover may be dirty due to dust in the air or gas emis-
sion from vehicles. That may degrade the quality of
images.
Check before connection
Compatibility of devices are restricted. Before connec-
tions, check the ratings and dimensions of the devices to
be used.
Contact your dealer for details.
Router
When connecting this product to the Internet, use a
broadband router with the port forwarding function (NAT,
IP masquerade).
Refer to the Operating Instructions (included in the CD-ROM)
for further information about the port forwarding function.
Procure fixing screws separately.
The screws that secure this product are not supplied.
Prepare them according to the material and strength of
the area where the product is to be installed.
/ –40 °C PoE+ (Power over Ethernet Plus)
Use a PoE+ hub/device that is compliant with IEEE802.3at
standard.
It is impossible to supply the power to this product from a
PoE hub that is compliant with IEEE802.3af standard.
Time & date setting
It is necessary to set the time & date before putting this
product into operation. Refer to the Operating Instructions
on the provided CD-ROM for descriptions of how to per-
form the settings.