Digitus RedRapid X User Manual page 81

Parameter
Disable WPS
WPS Status
Self-PIN Number
Description
Check to disable the Wi-Fi protected Setup.
When AP's settings are factory default (out of box), it is
set to open security and un-configured state. "WPS
Status" will display it as "UnConfigured". If it already
shows "Configured", some registrars such as Vista WCN
will not configure AP. Users will need to go to the
"Backup/Restore" page and click "Reset" to reload
factory default settings.
"Self-PIN Number" is AP's PIN. Whenever users want to
change AP's PIN, they could click "Regenerate PIN" and
then click " Apply Changes". Moreover, if users want to
make their own PIN, they could enter four-digit PIN
without checksum and then click " Apply Changes".
However, this would not be recommended since the
registrar side needs to be supported with four-digit PIN.
72