Turn switch
Switching off lights (except daytime running lights)
Switching lights on and off automatically
Switching on the parking light or parking lights
Switch on low beam
Pull switch
Switch on the front fog lamp
Switch on the rear fog light
» page 63
Headlight beam range regulation
Turning the dial
» Fig. 41
from the position
B
range is gradually adjusted, thereby shortening the beam of light.
The positions of the width of illumination correspond approximately to the fol-
lowing car load.
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
We recommend you adjust the headlight beam when the low beam is switched
on.
WARNING
Always adjust the headlight beam to satisfy the following conditions.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Note
The light switch is in position or and the ignition is turned off, the low
■
beam is switched off automatically and the status light is lit. The parking light
goes out after the ignition key is removed.
If there is a fault in the light switch, the low beam comes on automatically.
■
» page 62
» page 65
» page 63
in means the headlight beam
Daylight running lights (DAY LIGHT)
Read and observe
on page 60 first.
The daytime running lights (the only function) provides the lighting of the front
vehicle range.
The daytime running lights are switched on automatically if the following
conditions are met.
The light switch is in the position or
The ignition is switched on.
The parking aid is activated.
Activating/deactivating function on vehicles with Infotainment
The function can be activated/deactivated in the Infotainment system
tainment user manual, chapter Vehicle settings (CAR button).
Deactivating on vehicles without Infotainment
›
Switch off the ignition.
›
Pull the turn signal- and main beam lever
steering wheel, push down and hold in this position.
›
Switch on the ignition.
›
Hold the lever in this position for at least 3 seconds after switching on the
ignition.
Activating on vehicles without Infotainment
›
Switch off the ignition.
›
Pull the turning signal and main beam lever towards the steering wheel,
push it up and hold it in this position.
›
Switch on the ignition.
›
Hold the lever in this position for at least 3 seconds after switching on the
ignition.
WARNING
When the daytime running light is switched on, the parking lights (neither
at the front nor the rear) and the number plate lights are not lit. Therefore
always switch on the low beam when the visibility is poor.
» Fig. 41
on page 60.
»
Info-
(» Fig. 42
on page 62) towards the
Lights and visibility
61
Need help?
Do you have a question about the Fabia and is the answer not in the manual?
Questions and answers