Related Manuals for Zepter Tuttoluxo 6S cleanSy PWC-700
Summary of Contents for Zepter Tuttoluxo 6S cleanSy PWC-700
- Page 1 OPERATING INSTRUCTIONS - PWC-700 OPERATING INSTRUCTIONS PWC-700 1 - OVERVIEW OF TUTTOLUXO 6S (PWC-700)
- Page 2 2 - LIST OF ACCESSORIES AND FILTERS * Optional TUBE TUBE CARRIER CARRIER FUNCTION MOTOR PANEL PANEL STEAM CONTROL FILTER SLOT WARRANTY CARD: TUTTOLUXO 6S (PWC-700) DATE OF PURCHASE: SERIAL NO.: LOT NUMBER: NAME AND ADDRESS OF PURCHASER: FAULT/DEFECT: STAMP AND SIGNATURE OF RETAILER: AUTHORIZED SERVICE CENTRE NAME AND ADDRESS: E-MAIL: TEL:...
-
Page 3: Table Of Contents
TUTTOLUXO 6S INDEX OVERVIEW OF TUTTOLUXO 6S page 03 MAINTENANCE page 18 LIST OF ACCESSORIES page 03 9.1 Filters page 18 LIST OF FUNCTIONS page 04 9.2 Simply System page 21 LIST OF FEATURES page 04 9.3 Cleaning of Flex Tube page 21 4.1 Patented features: page 04... -
Page 4: Overview Of Tuttoluxo 6S
1 - OVERVIEW OF TUTTOLUXO 6S Motor push button Hose power connection Carrying handle Polyester filter Steam control Cable winding Function button Flaps of the water tank open Tank lid fasteners Water bucket, internal view Tank lid M Bottom view with Sensor Cap Hose connection socket SLALOM SYSTEM 2 - LIST OF ACCESSORIES AND FILTERS... -
Page 5: List Of Functions
3 - LIST OF FUNCTIONS Vacuuming - Wet & Dry with Water filter Steam Cleaning & Vacuuming at the same time Air Cleaning & Air Aroma Therapy Steam Cleaning & Disinfection Professional Steam Ironing Air Humidification 4 - LIST OF FEATURES TUTTOLUXO 6S water is sprayed in a micro-sized mist that instantly bonds to dirt Several features make your TUTTOLUXO 6S your special agent in the war against and dust particles, creating the unique Water Filter and removing them from the... -
Page 6: Spray System Tm , Slalom System Tm , Simply System Tm
SIMPLY SYSTEM 4.3 TECHNICAL DATA See Chapter 9 - Maintenance Data plate characteristics WARNING! Make sure the technical data on the data plate matches that of 4.2 SAFETY FEATURES your electricity mains. 4.2.1. Mechanical safety features: Technical characteristics • The safety pressure valve exit is placed on the bottom of the machine. •... -
Page 7: Important Safety Notice
If your mains socket is not compatible with the machine plug, have resting on the floor. the plug replaced with a suitable one by Zepter qualified personnel. The power cord must be completely unwound before use. Do not They should also check that the mains socket is suitable for the amount of damage the cord by squashing it, stepping on it, pulling it, knotting it or power required by the appliance. -
Page 8: Getting Started
Do not use the power cord to lift the appliance or to drag • Repairs must be performed only by a Zepter Service Centre and in accordance it about while you are cleaning! to national and local safety regulations. Unauthorised repairs could cause If you decide to no longer use the appliance, we recommend making it injury or machine damage. - Page 9 Water level Hose and accessories fitting Insert the hose with its connection into the SLALOM SYSTEM socket at the front and push the plug into the socket. (See Chapter 4.1: Patented Features, Slalom System In order to clean floors, it will be necessary to insert the proper accessories onto the special extension tube (Pict.7) by using the proper fit/release button (Pict.
-
Page 10: Vacuum Function
6.1 VACUUM FUNCTION Once you have inserted the hose, as previously described, to start the vacuum function press the motor push button (A), the orange light will come on to signal that the motor is set on medium speed ( Pict. 11). To start the motor, press the speed button (Pict. -
Page 11: Operation
7 - OPERATION 7.1 VACUUMING - WET & DRY WITH WATER FILTER 7.2 STEAM CLEANING & DISINFECTION Please only vacuum liquids such as water and spilled beverages. Always clean afterwards according to instructions below. As the right pressure is reached, the flashing orange light becomes steady, and steam is ready to be delivered. -
Page 12: Professional Steam Ironing
Description of iron A. Steam button B. Monotube C. Iron temperature light D. Iron temperature adjustment (Pict. 3) E. Iron rest Dry iron There is no need to use the steam button for dry ironing. Set the temperature adjustment on the iron (D) to the desired temperature, and wait for the light (C) to go out. -
Page 13: Air Cleaning & Air Aroma Therapy
Add a few drops of ZEPTER COSMETICS AROMA LIQUID to the water in the the air a refreshing steam-bath. To be used with flex-tube (Pict. 6) or optional water tank when vacuum cleaning. -
Page 14: Usage Of Accessories And Filters
8 - USAGE OF ACCESSORIES AND FILTERS 1. EXTENSION TUBES Two tubes with rapid lock system for choosing desired length. They are thermally insulated to protect against scalding. Max lenght 2.4 m. USEFUL TIPS How to use the Carpet Accessory 2.1 The vacuum performance is excellent in every situation, even along walls 2. - Page 15 Use the rear bristles on the brush itself to soften and remove heavy dirt and Gets into every corner and along the walls, loosening dust and dirt with its grime if necessary. bristles before vacuuming up. Use it on tiles to remove dust and light dirt. Always use delicately and without any liquid on the floor so that the bristles stay clean and do not wear down quickly.
- Page 16 with vacuum only. After vacuuming, use the appliance with simultaneous action (steam+vacuum), according to the same procedure recommended for medium dirty surfaces. With particularly stubborn and crusty stains, we recommend the use of 1 hole dress-fit (3) + large nozzle (3.2). WARNING! Steam ensures a good cleaning in any case, however, to pre- treat carpets or rugs with detergents, be careful not to vacuum off any foam produced as it could end up inside the motor! It is advisable to use low...
- Page 17 4. Carrier for accessories: DRESS-FIT TRIPLE JET 7. Carrier for accessories: To be used in conjunction with: 7.1 Liquid accessory with squeegee This accessory (4) combined with a special triangular brush, is particularly suitable for cleaning the oven and worktops, thanks to its shape and size. 7.2 Solids accessory with bristles 4.1 Triangular brush Combined with the Carrier for accessoires Dress Fit Triple Jet, this special brush...
- Page 18 1. FLOATER FILTER 9. IRON REST This filter traps the bigger dirt (e.g. leaves) Safety support to place the iron on. which is not caught by the rainstorm of the Spray System and is therefore an important gate-keeper and protector for the Air Intake Filter.
-
Page 19: Maintenance
9.1 FILTERS micro-organisms in indoor air. (Pict. 6). The following filters should be replaced immediately if you notice any damage to them! Contact your Zepter Service Centre for new filters. FLOATER FILTER This filter traps the bigger dirt (e.g. leaves) - Page 20 Once the filter cover is in place, new ones, to be found at a Zepter Service Centre. The life of this particular rotate it upwards for the final fixing with the stopping tongue.
- Page 21 After some periods of use, should the HEPA filter be torn or damaged, it should turning the appliance over, water is spilled be replaced with a new one from a Zepter Service Centre. on the motor fan. Find the lower cover and remove it by undoing the central screw, simply using your hands or a coin.
-
Page 22: Simply System
Polyester Filter (PWC-700-501): Replace yearly or earlier according to condition. Motor Intake Filter (PWC-700-533): Replace yearly or earlier according to In case one gets broken or lost, immediately ask for a spare part from your Zepter condition. Service Centre. Do not use the TUTTOLUXO 6S without it. Allow all pieces to dry Hepa Filter (PWC-700-516): Replace every 6-12 months. - Page 23 • Unscrew the electronic sensor by turning the knob anticlockwise, as shown in Pict. 15. • Use the specific funnel (6) to pour approximately half a glass of white wine vinegar (approx. 0.1 litres) into the boiler. Fasten the sensor to the boiler entrance by turning clockwise.
-
Page 24: Warranty Statement
10 - WARRANTY STATEMENT This appliance can only be assigned to the functions it has been designed for, installation and use, not in conformity with the warning listed in the i.e. house cleaning and air enhancement. The maker cannot be held responsible machine catalogue. -
Page 25: Troubleshooting
12 - TROUBLESHOOTING TROUBLE CAUSE SOLUTION After connecting the machine to the power outlet Unplug the machine. the LED for low water level starts flashing and an The water level in the tank is low. Fill up the water tank and plug it in again. acoustic signal is heard. -
Page 26: Use Of Accessories - Chart
13 - USE OF ACCESSORIES - CHART MARBLE/ ✔ ✔ ✔ ✔ ✔ ✔ ✔ ✔ ✔ ✔ ✔ STONE FLOOR ✔ ✔ ✔ ✔ ✔ ✔ ✔ ✔ CARPET ✔ ✔ ✔ ✔ ✔ ✔ PARQUET ✔ ✔ ✔ ✔...
Need help?
Do you have a question about the Tuttoluxo 6S cleanSy PWC-700 and is the answer not in the manual?
Questions and answers