Audio Setup; Recording Sound From The Internal Microphone; Recording Sound From An External Audio Device - Sony XDCAM PXW-X70 Operating Manual

To save the adjusted white balance
value in memory A or B
1 Set the AUTO/MANUAL switch D to
MANUAL.
2 Press the WHT BAL button to highlight
the white balance value.
3 Turn the MANUAL dial to select
A( A) or B(
4 Press the MENU button.
5 Press the v/V/b/B/EXEC buttons to
(CAMERA SET) t [WB
select
SET].
6 Frame a white object such as a piece of
paper that fills the screen under the
same lighting conditions as your
subject.
7 Press the EXEC button.
The adjusted value is stored in
B. The stored color temperature
appears for about 3 seconds.
z Tips
• If [WB SET] is assigned to an ASSIGN button,
the adjusted value is stored by pressing the
ASSIGN button when the shooting screen is
displayed, instead of performing step 4.
b Notes
• When a white balance adjustment value has not
been obtained successfully,
turns to slow flashing. Adjust the subject
appropriately and set the shutter speed to auto or
around 1/60 (when [60i] is selected)/1/50 (when
[50i] is selected), then try adjusting the white
balance again.
To adjust the white balance
automatically
Press the WHT BAL button A.
b Notes
• When you set the AUTO/MANUAL switch B
to AUTO, iris, gain, shutter speed and white
balance are adjusted automatically. You cannot
adjust manually.
B).
A or
A or B

Audio setup

The jacks, switches and dials shown below
allow you to set the sound that is recorded.
See page 5 for details on attaching the
microphone.
Recording sound from the
internal microphone
You can record sound in stereo using the
camcorder's internal microphone.
Internal microphone
Select [INT MIC] in the [MIC SELECT]
menu.
z Tips
• To reduce wind noise, set [INT MIC WIND] to
[ON].
Recording sound from an
external audio device
When using a microphone with XLR-type
connector (sold separately) or external
audio device (such as a mixer), configure
the settings as described below.
43
Continued ,