KitchenAid 528534 Installation Instructions Manual page 6

5. Open the drawer.
6. Press in the right-hand runner clip and push it back about 6"
(15.2 cm). Repeat with the left-hand runner clip.
NOTE: When removing the drawer there is limited range of
movement due to the attached water hoses.
7. Lift the right edge of the drawer off its runner. Slide that runner
back into the dishwasher.
8. Lift the drawer completely off the left-hand runner.
9. Set the drawer down flat on the protective covering. If the
drawer cannot be set down flat due to space constraints,
rotate it to the left onto its side, and place on the protective
covering. The drawer will need to be securely supported at a
height even with the cavity.
Bottom mount hole locations
10. Slide the left-hand runner back into the dishwasher.
11. Make sure chassis position is still aligned and mark holes in
the bottom (if using bottom mount option).
Option 1: Attach dishwasher (side mount)
1. The dishwasher side attaching tabs are accessed through
holes in the sound insulation.
IMPORTANT: For best installation, use all four attaching tabs.
Add spacers to side of cabinet if needed to attach screws.
Refer to "Cabinet dimensions/requirements" section.
2. Secure the attaching tabs to the cabinet using #8 Phillips
head screws.
NOTE: Before securing the dishwasher, confirm that the
chassis is still properly aligned.
6
3. Pull one of the bottom drawer runners all the way out. Make
runner clip
4. If the bottom drawer was rotated, rotate the drawer to unwind
5. While holding on to the drawer, fully extend the remaining
6.
7.
1. Temporarily reinstall drawer and remove entire dishwasher
2. Drill a 3/16" diameter pilot hole at each of the three locations
3. Replace dishwasher in opening and realign with chassis
4. Remove drawer and install the three 1" hex head screws and
side
mounting
5. Reinstall the drawer,
bracket
6. Check unit for side-to-
sure the latches on the back of the drawer runner are facing
forward.
drawer
runner
latch
bracket
the hoses and then put the drawer on the extended runner,
making sure the hoses are looping upward.
drawer runner. Follow the procedure in step 3 to place the
drawer on the remaining runner.
Make sure both runner clips have snapped into place. If they
have not, pull the runner clips forward until they do.
Close the drawer.
Option 2: Attach dishwasher (bottom mount)
from cavity.
marked.
mark.
the three 9/16" washers (all three screws and washers must
be used) using a minimum 20 in/lb torque.
following steps 3 through
7 in Option 1.
side movement. If it
moves, remove the
drawer and retighten the
screws. Then reinstall the drawer.
latch
Hex head screws and washers