Peg-Perego uno Instructions For Use Manual page 14

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ IMPORTANT: read these instructions carefully and
keep them for future use. The child's safety could
be at risk if these instructions are not followed.
_ This item was designed for the transport of 1 child in
the seat.
_ Do not use this item for a number of occupants
greater than that intended by the manufacturer.
_ This item is approved for children from birth up to a
weight of 15 kg in the seat.
_ This item was designed for use in combination with
1 Peg Perego Ganciomatic "Primo Viaggio" car seat
(Group 0+).
_ Before use check that the "Primo Viaggio" car seat
(Group 0+) is correctly fixed to the item.
_ The assembly and preparation of the item must be
carried out by an adult.
_ Do not use this item if there are parts missing or signs
of breakage.
_ Always use the five point harness; always use the
harness crotch strap in combination with the waist
strap.
_ It may be dangerous to leave your child unattended.
_ Always apply the brake when stationary.
_ Before use check that all the attachment mechanisms
are correctly engaged.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions as regards the maximum
loads transportable.
_ The front bar is not designed to support the child's
weight. It is not designed to keep the child in the seat
and does not substitute for the waist belt.
_ Do not load the baskets over 5 kg. Do not put weight
in the cup holder in excess of those indicated on the
cup holders themselves and never hot drinks. Do not
put loads of more than 0.2 kg in the hood pockets (if
present).
_ Do not use the item near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ The use of accessories not approved by the
manufacturer could be dangerous.
_ This item is not suitable for jogging or roller skating.
_ Apply the brake when loading or unloading children.
INSTRUCTIONS
1 OPENING: press both buttons on the handlebar at the
same time and lock it in the vertical position (fig_a).
Release the two clips (fig_b), pull the handle up firmly
(fig_c) then push it down until it locks into position.
2 FITTING THE HANDLE: Use a screwdriver to remove
the two screws, taking care not to lose them (fig_a).
Remove the caps on the ends of the handle and slot
it into the tubes (fig_b). Check the position with the
figure to ensure it is not on backwards. Fully tighten
the screws on both sides of the handle (fig_c), but do
not force them.
3 FITTING THE WHEELS: Place the large wheels
alongside their slots and push them in until they click
into place.
4 BASKET: to fit the basket, press the side buttons
(fig_a) and pull out the basket ring (fig_b). Check that
it is correctly positioned (fig_c).
5 Slide the ring into the basket fabric (fig_a) and push
it into the housing on the stroller until it clicks into
position. Clip the basket onto the buttons on the side
(fig_b) and slip the two loops onto the stroller at the
front. (fig_c).
6 The stroller basket has three positions. The normal
position can be seen in Figure A. The basket can be
lowered to allow it to be used even when the backrest
is completely lowered. By pressing on it, it is easier
to fill it without disturbing the baby (fig_b). The
basket can also be raised to allow access to the rear
footboard (fig_c).
7 FRONT BAR: insert the front bar (fig_a) and press
until the first click. Pull the levers under the front
bar towards you (fig_b) and insert it completely by
pushing it forwards (fig_c).
8 The front bar can be lengthened to two positions.
To move it to the first position, pull the two levers
underneath towards you (fig_a) and pull it until the
first click (fig_b). To move it to the second position,
pull the two levers and the front bar towards you
again until the second click (fig_c).
When your children are bigger, you can remove the
front bar. Press the buttons under the armrests (fig_d)
while pulling the front bar outwards at the same time
(fig_e).
9 CHILD TRAY: pull the front bar out to the second
position and attach the tray by pushing it downwards
(fig_a). You can remove it by pushing the two side
flaps of the tray outwards and lifting the tray at the
same time (fig_b).
10 BRAKE: to set the brake on the stroller, lift the lever on
the side of the handlebar (fig_a); to release the brake,
disengage the lever by pushing the release button
(fig_b). Always set the brake when the stroller is not
moving.
11 5-POINT SAFETY HARNESS: to attach the safety
harness, insert the two buckles of the waist strap
(with shoulder straps attached – arrow_a) into the
leg divider strap until it clicks into place (arrow_b). To
release, push the round button placed in center of the
buckle upwards (arrow_c) and pull the waist strap to
the sides (arrow_d).
12 To tighten the waist strap, pull on both sides in the
direction of the arrow (arrow_a). To loosen it do the
opposite. The waist strap can be tightened as far as
the safety lock (fig_b).
13 To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow_a) until
the buckles are released and insert them in the
backrest loops (arrow_b). Remove the shoulder straps
from the sack (arrow_c) and insert them in the most
appropriate loop (arrow_d), then re-attach the two
buckles on the rear of the backrest (arrow_e).
14 ADJUSTING THE BACKREST: the stroller backrest can
be reclined in three positions. To lower it, raise the
handle (fig_a) and at the same time lock it into the
desired position (fig_b); push upwards to raise it.
15 ADJUSTING THE FOOTREST: the footrest has
two positions. To lower it, pull the two switches
downwards and lower the footrest at the same time
(fig_a). To raise it, pull it up until it clicks (fig_b).
16 SWIVEL WHEELS: the smaller wheels on the stroller
swivel. To make them swivel, raise the lever (fig_a).
Lower the level to set them in their fixed position
(fig_b).
17 HANDLEBAR: to make the handlebar reversible,
pull the clips on it upwards at the same time (fig_a)
and move it to the other side until the final click.
IMPORTANT: take care not to hurt the child's hands
or arms when doing this. Adjust the height of the
handlebar by pressing on both side buttons at the
same time (fig_b).
- 14 -