Advertisement
Quick Links
CM-E
CM-EZ-II
CM-EZ-II
Z-II
Install Instructions
Flexible conduit clamp
Sheetrock/tile
Box contents
1 Speaker
1 Flexible conduit clamp
1 Tile bridge
(shipped separate)
Transformer Taps Settings
70.7 Volt Transformer Taps (dB)
CM-EZ-II
20 W=103, 10W=100, 5W=97, 2.5 W=94, 1.25 W=91
Voice Coil
8 Ohm=106 dB
Warning
S o u n d T u b e s p e a k e r s m u s t b e i n s t a l l e d b y a p r o f e s s i o n a l a u d i o
installer/contractor. For safety and for optimum audio performance,
installer must follow all directions issued by SoundTube Entertainment.
Tile bridge
Signal wires
100 Volt Transformer Taps (dB)
20W=103, 10W=100, 5W=97, 2.5W=94
|
1.435.647.9555
Safety cable stud
Tap switch
20 W, 10 W, 5 W, 2.5 W, 1.25 W, voice coil/8 Ohm direct
Grille bezel
© 2004 SoundTube Entertainment, Inc. All rights reserved. REV 07.27.04
25 Volt Transformer Taps (dB)
2.5 W=94, 1.25W=91, .63W=88, .32W=85, .16W=82
Warning
Do not spec or install speaker near support beam, ventilation
duct or other structure that may interfere with speaker function
or dispersion.
|
800.647.TUBE
www.soundtube.com
Blind-mount
backcan
Snap cam
Advertisement
Related Manuals for SoundTube CM-EZ-II
Summary of Contents for SoundTube CM-EZ-II
- Page 1 1 Speaker 1 Flexible conduit clamp 1 Tile bridge (shipped separate) Transformer Taps Settings © 2004 SoundTube Entertainment, Inc. All rights reserved. REV 07.27.04 70.7 Volt Transformer Taps (dB) 100 Volt Transformer Taps (dB) 25 Volt Transformer Taps (dB) CM-EZ-II 20 W=103, 10W=100, 5W=97, 2.5 W=94, 1.25 W=91...
- Page 2 CM-EZ-II CM-E CM-EZ-II Z-II Drop Tile Ceiling Install Instructions 1.435.647.9555 800.647.TUBE www.soundtube.com 9.75" (248 mm) Remove ceiling tile. Using supplied tile bridge, 3. Cut hole in tile using key- 4. Set tap to proper setting. mark hole. hole saw or Roto-Zip tool.
- Page 3 CM-EZ-II CM-E CM-EZ-II Z-II Sheetrock Ceiling Install Instructions 1.435.647.9555 800.647.TUBE www.soundtube.com 3. Set tap to proper setting. Thread tap & signal wires Using supplied template Cut hole in tile using key- or, tile bridge to mark hole saw or Roto-Zip tool.
- Page 4 CM-EZ-II CM-E CM-EZ-II Z-II Pre-construction Install Instructions 1.435.647.9555 800.647.TUBE www.soundtube.com 4. Set tap to proper setting. Install pre-construction Complete finishing work. Remove rubber feet from bracket with lip facing cams, allowing room for CM-EZ-8 is factory preset down. Use nails or screws pre-construction bracket.
Need help?
Do you have a question about the CM-EZ-II and is the answer not in the manual?
Questions and answers