NEC M100 Installation Manual page 23

・ Use an appropriate method to fasten the rack to the floor. If an appropriate method cannot be found, attach
a stabilizer. Someone might be injured if vibration caused the rack to tip over.
・ Connecting a UPS is recommended to prevent data loss due to a power failure.
If a power failure occurs, operation of the disk drive may become unstable.
・ Before attaching a fiber channel cable to the connector, verify that no dust, dirt, or oil is adhering to the
connector.
・ A fiber channel cable is thin and easily damaged. Do not excessively bend it or force it into the device.
・ Moving the disk array unit through an extremely uneven area may subject the device to shocks or vibrations
and cause data loss.
Also, pay careful attention to steps or gaps in the floor surface (such as the gap at the entrance of an
elevator).
Caution
・ At least two people should carry a disk array unit on a slope since the weight will increase on one side.
・ When moving the rack up or down a slope, make sure the front and back of the disk array unit face the
direction of travel. If the side of the disk array unit faces the direction of travel, the unit may be damaged.
Instruction
――――― End ―――――
- 22-