Poor colour
Image is blurred
Picture rolls
No sound
The projector does not
react to commands from
the remote control
Indicators
Philips Multimedia Projector
7.Troubleshooting
•
Adjust 'Brightness', 'Contrast or 'Colour tracking' (see 'Picture adjustment' under 'Operation' -
'On Screen Display Menu').
•
Reset all projector settings in the 'Setup' menu ('Factory settings').
–
Image is not focused.
•
Adjust focus ring.
–
Distance between projector and screen is not correct.
•
Adjust the distance between the projector and the screen.
–
Signal cable is not correctly connected.
•
Connect signal cable correctly.
–
Signal cable is not correctly connected.
•
Connect signal cable correctly.
–
Audio cable is not correctly connected.
•
Connect audio cable correctly.
–
Volume is not adjusted properly.
•
Adjust volume.
–
(A/V-)Mute active.
•
Cancel (A/V-)Mute.
–
Distance is too great.
•
Reduce distance.
–
Batteries are exhausted.
•
Replace batteries (see 'Inserting the batteries in the remote control').
–
IR sensor is obstructed.
•
Remove obstacle.
Lamp indicator
–
Red blinking (0.5sec. On, 0.5sec. Off): lamp start has failed.
• Disconnect projector from the mains. Reconnect and restart. If this does not solve the
problem, replace the lamp. See 'Maintenance. '
–
Red blinking (1sec. On, 1sec. Off): the fans are locked.
• The projector will automatically shut down. If this problem persists, contact service center.
Temp. (temperature) indicator
–
Lights up red: temperature error.
• Disconnect projector from the mains. Reconnect and restart. If this does not solve the
problem, contact your service centre.
Standby indicator (text on Standby button/ring around Standby button)
–
Lights up green: Power on mode.
–
Green blinking: warming up in Power on mode.
–
Lights up red:: Standby mode.
–
Red blinking: cooling down in Power off mode.
28
English User guide bCool XG1
>