Electrical Installation; Electrical Wiring; Remote Wall Switch - Lexington Forge CONCORDE C28DV Operating Instructions Manual

Direct vent

Table of Contents

ELECTRICAL INSTALLATION

This stove will work without any electrical supply. Electricity is only needed if you install a remote wall mounted switch.

NOTE: If installed in mobile home, stove must be bolted securely to floor.

Electrical connections should only be performed by a qualified, licensed electrician.

Main power must be off when connecting to main electrical power supply or performing

service. All wiring shall be in compliance with all local, city, and state codes. The

appliance, when installed, must be electrically grounded in accordance with local

codes, or in the absence of local codes, with the National Electrical Code ANSI/ NFPA

70 (latest edition) and Canadian Electrical Code, CSA C22.1.

Label all wires before disconnecting when servicing controls. Wiring errors can cause

improper and dangerous operation.

Verify proper operation after servicing.

REMOTE WALL MOUNTED SWITCH

A remote wall switch and up to fifteen (15) feet of 18 Ga. wire may be used with this appliance. Attach the wall switch in a junc-

tion box at the desired location on the wall. See Figure 30. Do not extend beyond the wall switch wire length provided.

NOTE: Extended lengths of wire may cause the fireplace not to function properly. Longer length of wire

is permitted if the wire is made out of larger gauge (diameter) wire. Always check with local code.

��

Figure 30 - Wiring Diagram for Wall Switch

��

45D0028

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the CONCORDE C28DV and is the answer not in the manual?

Concorde c40dv