Page 1
ProLine Range Hoods Installation Guide ProLine Range Hoods Installation Guide Built-In Interior Power 18” Height Range Hoods ProLine Range Hoods, LLC 1750 South 500 West, Suite 200 Salt Lake City, UTAH 84115 USA www.prolinehoods.com...
ProLine Range hoods are euipped with variable speed controls for blowers. These units will not function with a single speed ventilator. All ProLine Range ventilator kits are designed specifically for use with ProLine Range hoods.
Check with a qualified and trained installer or local codes for makeup air requirement, if any. 3. Max. amp rating for hoods includes recommended ventilator kit rating; all products must be hard wired direct with 2-wire with ground. HEIGHT OF HOODS The bottom of the hood should be 30’...
Page 4
PREPARING FOR HOOD INSTALLATION Plan where the ductwork will be located. Install proper-sized duct work, and roof or wall cap for the type of blower you are using. Recommended hood locations for the most common installations are shown on page 2. Adjust your measurements for various heights of ceilings, soffits, cabinets, or ranges/rangetops.
Page 5
DESCRIPTION FILTERS SPACERS HALOGEN CFM. (bulb sold MAXIMUM AMPS LIGHTS separately) 30” Wall Range Hood 1600 ProV30W-304 36” Wall Range Hood 1600 ProV36W-304 42” Wall Range Hood 1600 ProV42W-304 48” Wall Range Hood 1600 ProV48W-304 54” Wall Range Hood 1600...
Page 9
INSTALLING BLOWER AND CONNECTING DUCT – INTERNAL POWER 1. Attach the ProLine blower to screws in the inside top of hood with 4 nylon nuts provided, as shown below. 2. Connect ductwork using supplied transition and damper, with nut(s) provided.
Need help?
Do you have a question about the ProV30W-304 and is the answer not in the manual?
Questions and answers