Monitor Audio Mass W200 Owner's Manual
  1. Manuals
  2. Brands
  3. Monitor Audio Manuals
  4. Subwoofer
  5. Mass W200
  6. Owner's manual

Monitor Audio Mass W200 Owner's Manual

Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

MASS
W200
o w n e r s m a n u a l

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Mass W200 and is the answer not in the manual?

Questions and answers

Related Manuals for Monitor Audio Mass W200

Summary of Contents for Monitor Audio Mass W200

  • Page 1 MASS W200 o w n e r s m a n u a l...
  • Page 3 To remove the MASS W200 from its carton place some protective material on the floor and having removed any loose items (mains lead(s) and 12 volt trigger lead) from the top of the packaging, carefully invert the carton.

  • Page 4: Positioning/Initial Set Up

    Leave the MASS W200 unplugged from the mains until the installation procedure is completed. The MASS W200 should now be sited in the most suitable position, preferably not directly in the corner of a room as this may cause excessive bass boom. Once a desirable position is achieved it is important to check if the cables are long enough to reach comfortably without being under tension.

  • Page 5: Amp Panel & Controls

    2. LFE Input (RCA Type) This input is to be used when connecting the MASS W200 to an AV amplifier/ receiver. When using the LFE input, the crossover frequency dial is not used. This is due to the crossover function being controlled by the AV amplifier/ processor to which it is connected.
  • Page 6 6. Bass Switch This switch tailors the bass response of the MASS W200 to your tastes. There are three settings: Music, Movies and Impact. In Movie mode, it provides a relative flat response down to 35Hz.

  • Page 7: Specification

    Specification System Format :- Active sub-woofer system – Auxiliary (ABR) loading. 18mm MDF cabinet (CARB2 approved) Low Frequency Limit :- 30Hz (-6dB) Upper Frequency Limit :- Variable 40 – 120 Hz @ 24dB/Octave Amplifier Power Output :- 220 Watts @ 1% THD+N Amplifier Classification :- Class D amplifier with Switch mode power supply (SMPSU) Bass EQ Switch :-...

  • Page 8: Troubleshooting

    Auto or On position, and signal source turned on? Try adjusting the volume level of the source. If it still does not turn on/ power up, please contact your local dealer/ distributor or Monitor Audio immediately. No sound from subwoofer.

  • Page 9: Owner Information

    Owner Information Product Details Model MASS W200 Product Serial No ………………………………….. Date of Purchase …………………………………… Dealer Details Dealer Name ……………………………………………………………………………………………. Address ………………………………………………………………………………………………… Town, Post code, Country ……………………………………………………………………………. e-mail address ………………………………………………………………………………………… Monitor Audio reserves the right to alter specifications without notice. monitoraudio.com...

Table of Contents

Save PDF