A.c. wire-in single and/or multiple station (24 devices) ionization smoke alarm with 9 volt battery back up and “hush” control to temporarily silence nuisance alarms (8 pages)
Page 1
For models: 1235, 440379 Smoke and Fire Alarm User’s Guide A.C. Wire-in Single and/or Multiple Station (24 Devices) Ionization Smoke Alarm Thank you for purchasing this smoke and fire alarm. It is an important part of your family’s home safety plan. You can trust this product to provide the highest quality safety protection.
In such units, install the smoke alarm on an inside wall with the top edge of the alarm at a minimum of 4” (10 cm) and a maximum of 12” (30.5 cm) below the ceiling (see Diagram A).
• When mixing models which have battery backup (1275, 1275H, 1285, PE 120, HD135F) with mod- els without battery backup, (1235, 120X, SL177I) be advised that the models without battery back- up will not respond during an AC power failure.
Install FIGURE 3. FIGURE 4. LED INDICATORS: This smoke alarm is equipped with red and green LED indicators. The red LED is located under the test button and has two modes of operation. Standby Condition The red LED will flash every 30-40 seconds to indicate that the smoke alarm is operating properly.
• If the alarm is located outside the bedroom or on a different floor, it may not wake up a sound sleep- • The use of alcohol or drugs may also impair one’s ability to hear the smoke alarm. For maximum protection, a smoke alarm should be installed in each sleeping area on every level of a home.
If after reviewing this manual you feel that your smoke alarm is defective in any way, do not tamper with the unit. Return it for servicing to: KIDDE Safety, 1394 South Third St., Mebane, NC 27302. (See Warranty for in-warranty returns)
Need help?
Do you have a question about the 1235 and is the answer not in the manual?
Questions and answers