Kyocera ECOSYS FS-1020MFP Service Manual page 101

3 in 1 20/21 ppm model
Error Code
E-0001
E-0002
E-0003
E-0004
E-0007
E-0008
E-0009
E-0012
E-0014
E-0015
E-0017
Message Dis-
played in KYOC-
ERA Net client,
and the Status
Monitor
Non-genuine The installed toner container
toner is installed is non-genuine.
Error has The installed toner con-
occurred tainer's regional specification
does not match the
machine's.
Memory full Scanning cannot be per-
formed due to insufficient
memory of scanner.
Error has The number of scanned
occurred pages exceeds the maxi-
mum number.
Add toner The toner has run out.
Cover open The rear cover or front cover
is open.
Top tray full The top tray is full of paper.
Memory overflow Unable to continue the job as
the memory is used up.
Add paper The paper size and paper
type settings selected at the
time of printing are different
from the KYOCERA Net cli-
ent settings.
Not connected The machine cannot perform
this job due to a disconnec-
tion of the USB cable.
- The USB cable is not con-
nected.
Cannot find KYOCERA Cli-
ent Tool or the appropriate
printer driver.
Meaning
1-4-25
2M4/2M5/2M6/2M7-1
Remedy
When you want to use the toner
container currently installed,
press [Stop / Reset] and [Mode
Select] key simultaneously for 3
seconds or more.
Install the specified toner con-
tainer.
Only the scanned pages are
available. Press [Stop/Reset]
key and the job will be canceled.
The maximum number of
scanned original pages is 99.
Only the scanned pages are
available. Press [Stop/Reset]
key and the job will be canceled.
Replace with a new toner con-
tainer.
Close the rear cover or front
cover.
The machine pauses after 100
sheets are printed. Remove
paper from the top tray and
press [Start] to resume printing.
Change the print resolution from
Fast 1200 to 600 dpi. Refer to
Printer Driver User Guide.
Check the paper size and paper
type settings.
Press [Stop/Reset]Key and con-
nect the USB cable.
Press [Stop/Reset] key and con-
nect the USB cable.
Press [Stop/Reset] key. Open
KYOCERA Client Tool or install
the appropriate printer driver.