Philips LX2600D Service Manual page 10

Procedure to change Tuner Grid
During the standby mode, hold the SOURCE and PLAY
buttons down and press the STANDBY button.
The display will show the new tuning grid "GRID 9" or
"GRID 10".
Note: Repeating the same action will toggle back to its
previous tuning grid setting.
Region code chage is done as follows:
1) Power up the set and open tray in DVD mode.
2) Press <9999> follow by <X> buttons on the Remote
control.
where x = numeric 1 to 6 denoting the regions below:
1 = USA
2 = Europe
3 = Asia Pacific
4 = Australia, New Zealand, Latam
5 = Russia, India
6 = China
Reprogramming of DVD version Matrix
After repair of the Mono AV board the customer setting
and region code may lost.
Reprogramming will put the set back in the state in which
it has left the factory, ie. with the default setting and the
allowed region code.
To reprogram do as follow:
1) Put the set in Stop mode with tray open
2) Press the following buttons on the Remote Control:
<9> <9> <9> <9> <AUDIO> <5> ........ for LX2600D/ 97
(Tuner - Non -Cenelac)
<9> <9> <9> <9> <AUDIO> <6> ........ for LX2610D/93
(Tuner Non- -Cenelac)
* Note: Please make sure the right tuner is used.
3-2
Procedure for check Software version
1) Power up the set and open tray in DVD mode.
2) Press OSD button on the Remote control.
3) The TV screen will shows:
SERVO:nnnnnnnn REG:r
LX3600D-yymmdd-Vxx
where
nnnnnnnn = servo version number
r = region number
yymmdd = software date in year, month, day format
xx = version number
SSS = stroke version eg: / 97 or /93
Procedure to upgrade software
1) Power up the set and open tray in DVD mode.
2) Place upgrade CD-ROM onto tray and close.
3) The set will response and display the following:
- LOAD [After the disc is read, the tray will open for you
to remove the disc]
- ERASE 0 -> ERASE F ...... -> ERASE 0
- WRITE F ...... -> WRITE 0
- UPG END [only for a short moment, if unsuccessful
ERROR is displayed]
- DISC
- LOAD [Tray will close indicating that the upgrade
process is completed]
4) Unplug the set to disconnect the mains supply.
5) The whole process should last for about 5 minutes.
Remove the upgrade CD-ROM and unplug the Mains
supply.