Samsung CY-SWR1100 Quick Installation Manual page 5

Plug & Access
The Plug & Access function lets you easily connect your Plug & Access compliant Samsung TV to
your Samsung wireless router by using a USB memory stick to transfer the setup information from
the router to the TV.
* Plug & Access is only supported by some Samsung TVs made in 2011 and after. For more
information, see the manual of the individual TV.
*
USB flash memory Requirements
File system - FAT16 or FAT32
Free space - 2KB (Minimum)
To connect a Samsung TV using Plug & Access, follow these steps:
1. Turn on the Samsung wireless router and your TV.
2. Insert a USB memory stick into the USB port in your
Samsung wireless router. Check the router' s LED
to make sure it is on (Blinking → on).
'
3. About a minute later, take the USB memory stick out of
the router, and then insert it into a USB port on your
Samsung TV. Samsung TV downloads the connection
information from the USB memory stick.
4. Wait until the connection is automatically established.
*Note : If Plug & Access does not connect your TV to your
wireless router, a pop-up window appears on the screen
notifying you of the failure.
If you want to try using Plug & Access again, reset the AP,
CY-SWR1100
disconnect the Samsung Wireless LAN adapter and then try
again from Step 1. You can also choose one of the other
connection setup methods.
5. The network connection screen appears, and the network setup
is complete.
6. Place the wireless router in a desired location.
*Notes:
• If the wireless router' s settings change or you install a new
wireless router, you must perform the Plug & Access procedure
again, beginning from Step 1.
• After the connection data transfer has been completed,
the WPS light on the router glows continuously.
English-5