Related Manuals for Pioneer PDWB-5003
Summary of Contents for Pioneer PDWB-5003
- Page 1 INSTALLATION MANUAL PLASMA DISPLAY MOUNT MODEL For service and parts contact 3130 E. Miraloma Ave. Anaheim, CA 92806 Phone: 800 368-9700 Fax: 800 832-4888 VISIT US AT WWW.PREMIERMOUNTS.COM...
-
Page 2: Table Of Contents
Contents Safety & precautions Mount diagrams Parts List Optional Adapters Installing the mounting bracket Installing the mount Electrical Securing the mount Checking for proper safety and security... -
Page 3: Safety & Precautions
Safety & Precautions WARNING: Safety precaution measures must be practiced at all times during the installation of this product. Use proper safety gear and tools for the installations procedure to prevent personal injury or damage to the plasma displays or plasma mounts. The wall or ceiling structure must be capable of supporting at least five (5) times the weight of plasma display. -
Page 4: Mount Diagrams
Mount Diagrams UNIVERSAL FLAT MOUNT 19.500 PART#: 16.000 0.500 Ø0.375 (x4) 2.125 PDB-UWFB 0.375 MATERIAL: 1.528 12 (GA) CRS COLOR: Black powder coat 8.750 Ø2.500 Lag bolt access slot. 4.500 12.000 14.324 17.500 Mounting points (4.5") used on installations other than wall mounting. Access hole for power or cables. -
Page 5: Parts List
Parts List HARDWARE LIST SIZE DESCRIPTION 5/16” Dia Lag bolts & flat washers Mounting bracket PDB-UWFB (back plate) M6 x 12 (mm) Phillip security Used for additional security on screws mobile carts, floor stands and ceiling mounts Installations instructions M8 x 20 Phillip screws Mount hardware TOOLS &... -
Page 6: Installing The Mounting Bracket
Installing the mounting bracket WARNING Proper installation procedure by qualified personnel as outlined in the installation instructions must be adhered to. Failure to do so could result in serious personal injury and possible damage to the plasma display. Step 1 CAUTION : The plasma displays are fragile and heavy. -
Page 7: Installing The Mount
Installing the mounts Step 3 Select the area where the plasma will be installed and make sure it can support the weight standards (see warning on page 3). Locate the 16" wood stud centers behind the wall using a (commercially available) stud finder and mark the center of the studs when found. Set the mounting bracket to the wall and mark the desired height by marking the center of the See fig 3 Flat back plate Desired height... -
Page 8: Electrical
To determine the desired viewing height, use the center slot opening in the wall mount as a center reference for the plasma television when mounted. Once the height is determined, use the bubble level to insure that the bracket is level. Next, using a pencil, mark the four (4) lag bolt slot openings on the mounting bracket. Before continuing, confirm the marks are located on the center of the studs. -
Page 9: Securing The Mount
Securing the mount Step 5 Warning: The plasma display is heavy and 2 people are needed to lift and install it. Failure to do so could result in serious personal injury. Before placing the plasma on the wall recheck all hardware for proper tightness and security. Before installing, become familiar with the way the plasma mount attaches to the wall mount.