Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Chromlech JARAG-5
Summary of Contents for Chromlech JARAG-5
-
Page 1: User Manual
JARAG-5 User Manual Rev D JA121 - JA221 FW V2.3... - Page 2 Chromlech Chromlech 19, avenue Gabriel Fauré 35235 THORIGNE-FOUILLARD FRANCE Tel: +33 (0)2.23.20.77.67 Fax: +33 (0)2.23.20.75.71 E-mail: contact@chromlech.com Web: www.chromlech.com...
-
Page 3: Table Of Contents
Table of Contents Table of Contents ....................... 1 1. The JARAG-5 ........................2 Lamp array ..........................2 Internal sequencer ........................6 DMX channel personality ......................3 25 DMX channel personality ...................... 3 31 DMX channel personality ...................... 3 JA121 dimensions ........................4 JA221 dimensions ........................ -
Page 4: The Jarag-5
DMX controller. Lamp array The JARAG-5 has a 25 lamp array. The type of lamp used depends on the lighting system model: The JA121 takes PAR20 lamps (GU10), and the JA221 takes PAR30 lamps (E26). -
Page 5: Dmx Channel Personality
The sequences are programmed using special software supplied free of charge (downloaded from www.chromlech.com) that operates under PC/Windows. The sequences can be defined and then uploaded into the lighting systems. A graphic interface allows for simulating the sequences that have been defined. -
Page 6: Ja121 Dimensions
JA121 dimensions 576 mm 240 mm 209 mm 63 mm diam. JA121 – front view JA121 – side view JA221 dimensions 576 mm 269 mm 238 mm 95 mm diam. JA221 – front view JA221 – side view JARAG-5 User Manual... -
Page 7: Installation
The JARAG-5 can be installed in any orientation. Direct fastening There are 24 M10 holes on the edges of the JARAG-5 chassis (12 at the front and 12 at the back) so that the lighting system can be suspended using hooks, slings or shackles. -
Page 8: Precautions In Use
3. Precautions in use The JARAG-5 lighting system has its own power control unit and is designed to be connected directly to the mains. It must not be powered through a dimmer. Switch off unit before disconnecting mains. The lighting system should be disconnected from the mains before any maintenance or relamping operation. -
Page 9: Control Panel
Min distance to lighted object : 1 m Min distance to flammable objects : 1 m Max ambient temperature : 40°C Made in France Max exterior surface temperature : 60°C STATUS POWER − EXIT ENTER DMX IN DMX OUT RS232 Control panel (rear) JARAG-5 User Manual... -
Page 10: Connectors
Function SubD 9 pin female Type Serial link to PC Pinout 1: Not connected 2: TX (output) 3: RX (input) 4: DTR (input) 5: Ground 6: Not connected 7: Not connected 8 Not connected 9: Not connected JARAG-5 User Manual... -
Page 11: Indicators
Normal operation Malfunction. Maintenance required. No DMX signal Green DMX signal OK Green flashing Occasional DMX errors: poor quality DMX signal orange Check the connections and signal integrity. DMX connection fault or polarity inversion: DMX signal not usable JARAG-5 User Manual... -
Page 12: Setup Menu
(or) Exit Enter Addr Set DMX address PErS Set DMX mode Rotation tESt Lamp test diMM DIMMER CtrL SPEd Manual control SPEED FAdE FADE Soft Software version SEQUENCE DISP Set display mode Banh BANK DfLt Default settings JARAG-5 User Manual... - Page 13 Off = the display shows the DMX address and goes off after about 1 minute Dflt Function Restores the default settings Value This sets the following values: DMX address = 1, personality = 6 channels, rotation = 0°, display = On JARAG-5 User Manual...
-
Page 14: Dmx Control
Full On, starting from the first step of the sequence Channel 2 Speed Step Fast Slow Step 1 Step 32 100% Synchronise sequence to first step (Flash) Channel 3 Cross-fade Low-voltage lamp effect Fast Slow Slow 100% Fast JARAG-5 User Manual... - Page 15 51 ... 62% None 90° 63 ... 75% Vertical 90° 76 ... 87% Horizontal 90° 88...100% Vertical + horizontal 90° Channel 5 Sequence selection Sequence 1 100% Sequence 16 Channel 6 Sequence bank selection Bank 1 100% Bank 16 JARAG-5 User Manual...
-
Page 16: Channel Personality (Matrix)
Speed / step Channel 3 Cross-fade / low-voltage lamp effect Channel 4 Rotation / reflection Channel 5 Sequence Channel 6 Sequence bank Channel 7 to 31 Matrix control (25 channel mode) Channel 7 Lamp 1 Channel 31 Lamp 25 JARAG-5 User Manual... -
Page 17: Programming
6. Programming The sequences are programmed using the "Jarag Control Center". This program can be downloaded from www.chromlech.com Further information can be found in the program documentation. JARAG-5 User Manual... -
Page 18: Specifications
Mains cable (Neutrik PowerCon) DMX in (XLR5), DMX out (XLR5) RS232-C (SubD9) 8. Part numbers JA121 Jarag-5 (for aluminium reflector PAR20 / GU10 lamps) JA221 Jarag-5 (for aluminium reflector PAR30 / E26 lamps) JA102 Kit of 25 PAR20 (25°) lamps for JA121 JA202 Kit of 25 PAR30 (10°) lamps for JA221... -
Page 19: Sequence Table
Sequence table JARAG-5 User Manual... - Page 20 (page left intentionally blank) JARAG-5 User Manual...
Need help?
Do you have a question about the JARAG-5 and is the answer not in the manual?
Questions and answers