Topcat And Media Connector Registration - Lightspeed Topcat User Manual

TOPCAT AND MEDIA CONNECTOR
REGISTRATION
The TOPCAT and Media Connector must be registered or synchronized with
each other before they will operate together. (These components come
pre-registered from the factory.) On occasion, one of these modules may be
replaced so the registration process will be needed.
Use the following table to determine if your TOPCAT and Media Connector are
registered.
NOTE: If the link LED on the Media Connector is continuous green, the
following procedure does not need to be done.
To register TOPCAT with its Media Connector:
1. Locate the registration buttons on the TOPCAT and Media Connector.
2. Start the procedure by pushing
the registration button on the
TOPCAT. An amber LED will light.
You will have 20 seconds to push the
corresponding registration button
on the Media Connector.
3. Push the registration button on the
Media Connector. The amber LED
will begin to blink. When registration
is complete, the link LED will glow
green and the amber LED will go off.
26
MC Power
OFF
ON/ Blinking Green
Unregistered
ON Continuous Green
TOPCAT
Media Connector
MC LINK LED
All LEDs Off
Registration Buttons
Status
Turn MC Power on Blue
LED is LIT
Not Linked - Needs to be
registered
Linked to TOPCAT
Paging
Input
Microphone
ADJ
CH B CH A
24V 2.5A
NOTE: If after pushing the
Registration button on TOPCAT the
corresponding button on the Media
Connector is not pushed within 20
sec., the amber LED will go from
a slow blinking to a fast blinking.
This means the registration process
has timed out. Wait until the amber
LED stops blinking to start the
registration again.
Registration