Installing Components - HP Rack Storage/12 Installation Manual

Chapter 3

Installing Components

1. Install the power supplies in the rear chassis slots. Secure each power
supply assembly with two thumbscrews (see Figure 3-4).
RS/12 SCSI Cards
2. Install the RS/12 SCSI card in slot 1 (right slot) in the rear chassis. Secure
the adapter with two thumbscrews.
3. Install the second RS/12 SCSI card or a blank filler panel in slot 2 (left
slot) in the rear chassis. Secure with two thumbscrews.
4. Install the Management Board in the rear chassis slot. Secure with two
thumbscrews.
5. Install the hard drives, filler panels and spacers in the drive cage
according to your disk array configuration requirements (see "Replacing
Hot-Swap Hard Drives" in Chapter 5).
24
Installing the HP Rack Storage/12 in a Rack
Power Supplies
Figure 3-4. Installing Components
Management Board